User manual SONY CPD-G500

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Then move the control button </, to make the adjustment. Select To rotate the picture expand or contract the picture sides shift the picture sides to the left or right adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Then move the control button </, to make the adjustment. You can adjust the R (red), G (green), B (blue) component of the input signal when making changes to items 2 and 3. If you fine tune the color temperature, the new color settings are stored in memory for each of the three color temperatures and item 1 of the on-screen menu change as follows. However, in order to display the sRGB colors correctly (=2. 2, 6500K), you must set your computer to the sRGB profile and adjust the brightness ( ) and contrast (6) to the numbers shown in the menu. for information on how to change the brightness ( ) and contrast (6) , see page 10. Note Your computer and other connected products (such as a printer), must be sRGB compliant. The colors of most display monitors tend to gradually lose brilliance over several years of service. The IMAGE RESTORATION feature found in the EASY and sRGB menus allows you to restore the color to the original factory quality levels. The explanation below explains how to restore the monitor's color from the EASY menu. You can manually degauss (demagnetize) the monitor, change the menu position, and lock the controls. The picture disappears while the color is being restored (about 2 seconds). After the color is restored, the picture reappears on the screen again. notes · Before using this feature, the monitor must be in normal operation mode (green power indicator on) for at least 30 minutes. If the monitor goes into power saving mode, you must return the monitor to normal operation mode and wait for 30 minutes for the monitor to be ready. You may need to adjust your computer's power saving settings to keep the monitor in normal operation mode for the full 30 minutes. If the monitor is not ready, the following message will appear. Adjust the selected item according to the following instructions. The monitor is automatically demagnetized (degaussed) when the power is turned on. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. The monitor may gradually lose its ability to perform this function due to the natural aging of the picture tube. [. . . ] The energy requirements include a demand that the computer and/ or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. the length of time to reactivate the computer shall be reasonable for the user. Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. Below you will find a brief summary of the environmental requirements met by this product. [. . . ]