User manual SONY CPD-L133

[. . . ] The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Macintosh II series and some older versions of Power Book models may need an adapter with micro switches (not supplied). Step 2: Connect the power cord With the monitor switched off, connect one end of the DC power cord to the monitor and the other end to a power outlet. Getting Started Getting Started Step 3: Attaching the rear cover After connecting the computer and power cord, attach the supplied rear cover. Make sure that you keep the screen upright when attaching the rear cover. First turn on the monitor, then turn on the computer. To maximize the potential of your monitor, install the new model information file from the supplied Windows Monitor Information Disk/Utility Disk onto your PC. This monitor complies with the "VESA DDC" Plug & Play standard. If your PC/graphics board complies with DDC, select "Plug & Play Monitor (VESA DDC)" or this monitor's model name as the monitor type in the "Control Panel" of Windows 95/98. If your PC/graphics board has difficulty communicating with this monitor, load the Windows Monitor Information Disk/Utility Disk and select this monitor's model name as the monitor type. Insert the tabs on the back of the rear cover into the catches, and then push down. 0 is different from Windows 95/98 and does not involve the selection of monitor type. 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. Turn the screw to fasten the rear cover. Further fine adjustments may be needed with some computers. You can select the OSD language from English, French, German, Spanish, Italian, and Japanese. The picture is adjusted to fit the center of the screen. This function is intended for use with a computer running Windows or similar graphic user interface software that provides a full-screen picture. It may not work properly if the background color is dark or if the input picture does not fill the screen to the edges (such as an MS-DOS prompt). The screen may go blank for a few seconds while performing the auto-sizing function. If the picture is flickering or fuzzy even after you press the AUTO button Before adjusting Connect the monitor and the computer, and turn them on. Wait for at least 30 minutes before making adjustments for the best result. Once the contrast is adjusted, it will be stored in memory for all input signals received. [. . . ] This section may help you isolate the cause of a problem and as a result, eliminate the need to contact technical support. symptom No picture If the u indicator is not lit If the "NO INPUT SIGNAL" message appears on the screen, or if the u indicator is orange · The screen is blank when the monitor is in power saving mode. Try pressing any key on the computer keyboard. Check that your computer power switch is in the "on" position. [. . . ]