User manual SONY CPD-L181

[. . . ] The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You can select the OSD language from English, French, German, Spanish, Italian, and Japanese. Most adjustments are made using the MENU OSD. Adjust the phase when the characters or pictures appear fuzzy throughout the entire screen. Adjust the pitch when the characters or pictures are not clear at some parts of the screen. You can adjust settings such as the backlight, OSD position, power saving delay time and control lock. Further fine adjustments may be needed with some computers. If this operation does not work, adjust the Pitch and Phase as follows. Once the pitch and phase are adjusted, they will be stored in memory for the current input signal. The monitor adjusts the pitch to match the input signal so that the picture appears sharp, and fits the picture to the center of the screen. If the resolution of the graphics board is lower than 1280 × 1024, set ZOOM to REAL (page 12). Use the appropriate disk for your computer. This function is intended for use with a computer running Windows or similar graphic user interface software that provides a full-screen picture. It may not work properly if the background color is dark or if the input picture does not fill the screen to the edges (such as an MS-DOS prompt). The screen may go blank for a few seconds while performing the auto-sizing function. If the picture is flickering or fuzzy even after you press the AUTO button If the picture is not in the center of the screen even after you press the AUTO button If the picture is not in the center of the screen, press the AUTO button. If this operation does not work, adjust the centering as follows. Once the centering is adjusted, it will be stored in memory for the current input signal. If horizontal stripes are observed over the entire screen, adjust the Phase in the next step. Adjust until the horizontal stripes are at a minimum. Move the picture up, down, left, or right until the frame at the perimeter of the test pattern disappears. For horizontal adjustment, select H using the / buttons and adjust the position using the +/­ buttons. To move the picture left CENTER H V 26 10When you have finished, click [END] on the screen to For vertical adjustment, select V using the / buttons and adjust the position using the +/­ buttons. [. . . ] The energy requirements include a demand that the computer and/or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. the length of time to reactivate the computer shall be reasonable for the user. Labelled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability. Below you will find a brief summary of the environmental requirements met by this product. [. . . ]