User manual SONY CPD-1201

[. . . ] INFORMATION This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPR II) for very low frequency (VLF) and extremely low frequency (ELF). iNFORMATION Ce produit est conforme aux normes du Swedish National Council for Metrology de décembre 1990 (MPR II) en ce qui concerne les fréquences très basses (VLF) et extrêmement basses (ELF). Hinweis Dieses Gerät erfüllt bezüglich tieffrequenter (very low frequency) und tiefstfrequenter (extremely low frequency) Strahlung die Vorschriften des , , Swedish National Council for Metrology (MPR)" vom Dezember 1990 (MPR II). If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications: SPECIFICATIONS Plug Type Nema-Plug 5-15p Cord Type SVT or SJT, minimum 3 × 18 AWG Length Maximum 15 feet Rating Minimum 7 A, 125 V This monitor is Energy Star Compliant when used with a computer equipped with VESA Display Power Management Signaling (DPMS). [. . . ] After the power has been turned on, the CRT is demagnetized for approximately 5 seconds. This generates a strong magnetic field around the bezel which may affect the data stored on magnetic tape or disks near the bezel. Place such magnetic recording equipment and tapes/disks at a distance from this unit. The socket-outlet shall be installed near the equipment and shall be easily accessible. Before using this monitor, please make sure that the following items are included in your package: Multiscan 15sfII/17sfII monitor (1), power cord (1), warranty card (1) and this operating instruction manual (1). This monitor will sync with any IBM or compatible system equipped with VGA or greater graphics capability. Although this monitor will sync to other platforms running at horizontal frequencies between 31 and 65 kHz, including Macintosh and Power Macintosh system, a cable adaptor is required. Please consult your dealer for advice on which adaptor is suitable for your needs. Step 1: With the monitor switched off, attach the power cord to the monitor and the other end to a power outlet. The Multiscan 15sfII/17sfII has factory preset modes for the 6 most popular industry standards for true "plug and play" capability. For less common modes, the Multiscan 15sfII/17sfII's Digital Multiscan Technology will perform all of the complex adjustments necessary to ensure a high quality picture for any timing between 31 and 65 kHz. This monitor complies with the DDC1TM* and DDC2BTM* which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor sycnchronizes with the V. With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 90° horizontally and 20° vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands. 0 kg (41 lb 14 oz) Design and specifications are subject to change without notice. Using a white background, very thin horizontal stripes on the screen are visible as shown on the illustration. These wires are attached to the aperture grille inside the Trinitron tube and are there to damp vibrations of the aperture grille in order to prevent them from influencing to the picture quality. This section may help you isolate a problem and as a result, eliminate the need to contact technical support, allowing continued productivity. No picture / If neither the u (power) indicator nor the POWER SAVING indicator is lit -- Check that the power cord is properly connected. -- Check that the power switch is in the "ON" position. / If the POWER SAVING indicator is lit -- Check that your computer power switch is in the "ON" position. [. . . ] / Try plugging the monitor into a different AC outlet, preferably on a different circuit. / Try the monitor on a completely different computer in a differnt room. Picture appears to be ghosting / Eliminate the use of video cable extension cables and/or video switch boxes if this symptom occurs. Excessive cable length or weak connections can procude this symptom. [. . . ]