User manual SONY CPD-1302

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] X sRGB The sRGB color setting is an industry standard color space protocol designed to correlate the colors displayed on the monitor and those printed. If you select sRGB, you cannot operate the BRIGHT/CONTRAST menu adjustments. note Confirm that the brightness ( ) and contrast ( ) values are adjusted respectively to the numbers to be set in the sRGB mode shown in the BRIGHT/CONTRAST menu. Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets. Try pressing any key on the computer keyboard or moving the mouse. Check that the graphic board is completely seated in the proper bus slot. X Letters and lines show red or blue shadows at the edges X A hum is heard right after the power is turned on This is the sound of the auto-degauss cycle. When the power is turned on, the monitor is automatically degaussed for a few seconds. * If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. A humming noise may be heard, but this is not a malfunction. Isolate and eliminate any potential sources of electric or magnetic fields such as other monitors, laser printers, electric fans, fluorescent lighting, or televisions. Try pressing any key on the keyboard or moving the mouse. Before the monitor enters power saving mode. If all 4 color bars appear (white, red, green, blue), the monitor is working properly. Reconnect the video input cables and check the condition of your computer. If the color bars do not appear, there is a potential monitor failure. (power) indicator lights up green, the monitor is working properly. Count the number of seconds between orange flashes of the ! (power) indicator and inform your authorized Sony dealer of the monitor's condition. Be sure to note the model name and serial number of your monitor. Also note the make and model of your computer and graphics board. When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor's memory to provide a high quality picture (see "Preset mode timing table" on page i). [. . . ] Clean the cabinet, panel and controls with a soft cloth lightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzine. Transportation When you transport this monitor for repair or shipment, use the original carton and packing materials. Use of the tilt-swivel This monitor can be adjusted within the angles shown right. [. . . ]