User manual SONY CPD-420GS

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The color palette setting and the actual number of colors are as follows: · True Color (24 bit) n about 16. 77 million colors In true color mode (24 bit), speed may be slower. If necessary, use the monitor's controls to adjust the picture. If no picture appears on your screen If NO INPUT SIGNAL appears on the screen, try changing the input signal, and confirm that your computer's graphics board is completely seated in the correct bus slot. If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer's graphics board so that the horizontal frequency is between 30 ­ 61 kHz, the vertical frequency is between 50 ­ 75 Hz, and the resolution is 1024 x 768 or lower. For more information about the on-screen messages, see "Trouble symptoms and remedies" on page 19. To maximize the potential of your monitor, install the new model information file from the supplied Windows Monitor Information Disk/Utility Disk onto your PC. This monitor complies with the "VESA DDC" Plug & Play standard. If your PC/graphics board complies with DDC, select "Plug & Play Monitor (VESA DDC)" or this monitor's model name as the monitor type in the "Control Panel" of Windows 95/98. If your PC/graphics board has difficulty communicating with this monitor, load the Windows Monitor Information Disk/Utility Disk and select this monitor's model name as the monitor type. Adjust until the horizontal stripes are at a minimum. Move the picture up, down, left, or right until the frame at the perimeter of the test pattern disappears. For horizontal adjustment, select H using the / buttons and adjust the position using the +/­ buttons. To move the picture left CENTER 10When you have finished, click [END] on the screen to For vertical adjustment, select V using the / buttons and adjust the position using the +/­ buttons. To move the picture down CENTER H V 26 26 When you have finished, click [END] on the screen to turn off the test pattern. Once the contrast is adjusted, it will be stored in memory for all input signals received. Once the brightness is adjusted, it will be stored in memory for all input signals received. Once the color temperature is adjusted, it will be stored in memory for all input signals received. If the screen is too bright when using the monitor in a dark room Decrease the BACKLIGHT (page 16). If you need to make further adjustments to the selected color temperature, go to step 4. The color changes as the R or B components increase or decrease with respect to G (green). [. . . ] the labelling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees) , Svenska Naturskyddsforeningen (The Swedish Society for Nature Conservation) and Statens Energimyndighet (The Swedish National Energy Administration). Approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety. The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. [. . . ]