User manual SONY CPJ-200

[. . . ] For the customers in the USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] If you do not input the correct password, you will not be able to project the picture. Power-on cannot be performed without the password. You will not be able to use the projector if you forget your password and the password administrator is not available. Be please aware that using the security lock can prevent valid usage in such cases. To use the security lock Press the MENU key and then, on the INSTALL SETTING menu, turn on the "Security Lock" setting. (The default initial password setting is "ENTER , ENTER , ENTER , ENTER. " After this is entered you can put in your own password. Therefore, when you use this function for the first time, please input "ENTER" four times. When the following message is displayed, the setting for security lock is completed. " is displayed on the menu screen, perform this procedure again from step 1. Next, the screen for entering the new password is displayed. "Freeze" appears when the key is pressed. This function works when a signal from a computer is input. Move the icon to the point on the image you want to enlarge. Use the arrow key (v/V/b/B) to move the icon. By pressing the + key repeatedly, the image size (ratio of enlargement: max. Use the arrow key (v/V/b/B) to scroll the enlarged image. The projector is equipped with an on-screen menu for making various adjustments and settings. Use the v or V key to select the item, then press the B or ENTER key. You can hide this indicator using "Status" on the MENU SETTING menu. When changing the adjustment level: To increase the number, press the v or B key. When changing the setting: Press the v or V key to change the setting. [. . . ] C If this message appears on the screen when using the projector at normal altitudes, check to see if anything is blocking the ventilation holes (exhaust). This input signal cannot be projected as the frequency is out of the acceptable range of the projector. You have input an RGB signal from the computer when "Input-A Signal Sel. If this message appears again after you replace the lamp, the lamp replacement process is not complete. [. . . ]