User manual SONY CPJ-D500

[. . . ] Before making connections Open the cover to use the AUDIO/VIDEO connector. * Connect only when you want to output the audio from the speaker of the projector. Connecting with a VCR/DVD player * Connect only when you want to output the audio from the speaker of the projector. The following three connecting options are available: a Composite video (phono plug) cable (not supplied) b S video (Mini DIN 4-pin) cable (not supplied) c Component (D-sub 15-pin y 3 × phono plug) cable (not supplied) Before connecting the equipment, plug the AC power cord into a wall outlet. [. . . ] The lamp remains hot after the projector is turned off with the ?If you touch the lamp, you may burn your finger. When you replace the lamp, wait for at least an hour for the lamp to cool. Pull out the lamp by holding the handle. If you touch the lamp, you may be burned or injured. When removing the lamp, make sure it remains horizontal, then pull straight up. If you pull out the lamp while it is tilted and if the lamp breaks, the pieces may scatter, causing injury. For safety reasons, do not loosen any other screws. Loosen the two screws on the lamp unit with the Phillips screwdriver (a). Fold out the handle (b), then pull out the lamp unit by the handle (c). Turn off the projector, and disconnect the AC power cord from the AC outlet. If the projector appears to be operating erratically, try to diagnose and correct the problem using the following instructions. Symptom Cause and Remedy The power is not turned on. The power has been turned off and on with the ?C Wait for about 45 seconds before turning on the power. The AC power cord was unplugged with the power of the projector turned on. C Connect the power cord to the AC outlet again, turn on the power of the projector, then turn it off. If your computer is compatible with DDC, turn the projector on according to the following procedures. The computer signal is not set to output to an external monitor or set to output both to an external monitor and a LCD monitor of a computer. c Set the computer signal to output only to an external monitor. C Depending on the type of your computer, for example a notebook, or an all-in-one LCD type, you may have to switch the computer to output to the projector by pressing certain keys or by changing your computer's settings. for details , refer to the computer's operating instructions supplied with your computer. [. . . ] If the LAMP/COVER indicator still lights even after you have replaced the lamp, the electrical system may break down. Flashes when the lamp cover is not secured firmly. I/1 indicator Lights in red when a AC power cord is plugged into a wall outlet. Once in standby mode, you can turn on the projector with the I/1 key. [. . . ]