User manual SONY CRU-40SG11

[. . . ] CRU-40SG11 Be sure to install this unit in the dashboard of the car for safety. For installation and connections, see the supplied installation/connections manual. CAUTION The use of optical instruments with this product will increase eye hazard. For the State of California, USA only Perchlorate Material – special handling may apply, See www. [. . . ] Rotate the control dial until “EQ7 PRESET” appears, then press it. Rotate the control dial until the desired equalizer curve appears, then press it. Press (BACK) to return to the previous display. 0 kHz Rotate the control dial to adjust the volume level, then press it. The volume level is adjustable in 1 dB steps, from -6 dB to +6 dB. To cancel the equalizer curve, select “OFF” in step 3. Tip The equalizer curve setting can be memorized for each source. Repeat steps  and  to adjust other frequency ranges. 6 Press (BACK) to return to the previous display. the equalizer curve is stored in “CUSTOM. € 17 Optimizing sound by Time Alignment — Listening Position The unit can simulate a natural sound field by delaying the sound output from each speaker to suit your position. Rotate the control dial to select “ON, ” then press it. 18 4 Press (BACK) to return to the previous display. Tip 1 2 3 During reception/playback, press , rotate the control dial until “SOUND” appears, then press it. Rotate the control dial until “SW DIREC” appears, then press it. Rotate the control dial until “SW MODE” appears, then press it. Rotate the control dial to select “1, ” “2” or “3, ” then press it. Press (BACK) to return to the previous display. The DM+ setting can be memorized for each source other than the tuner. Using rear speakers as subwoofer — Rear Bass Enhancer Rear Bass Enhancer enhances the bass sound by applying a low pass filter setting (page 20) to the rear speakers. This function allows the rear speakers to work as a subwoofer if one is not connected. 4 5 For details on the settings for the subwoofer phase, position, low pass filter frequency and the low pass filter slope, see page 21. [. . . ] € Disconnect the USB device, then change the source by pressing . € Indicates that the USB device is out of order, or an unsupported device is connected. READ  The unit is reading all track and album information on the disc. € Wait until reading is complete and playback starts automatically. [. . . ]