User manual SONY CRX-100E

[. . . ] This unit uses CD-R discs with the following mark. This unit uses CD-ROM discs with the following mark. When you use this unit as a CD player, use compact discs with the following mark. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] Unplug the computer and disconnect the cables attached to the back to give yourself more room to work. Do not turn on the power of the computer before completing the entire installation process. Set the jumpers on the rear of the drive in accordance with the configuration of your computer system. When the CRX100E is daisy-chained with a Hard Disk Drive on an IDE Card, set the Hard Disk Drive as MASTER and the CRX100E as SLAVE. However, it should be noted that some personal computers may use CSEL in lieu of the foresaid MASTER/SLAVE selection. In this case, remove the existing jumpers from MASTER and SLAVE, and set a jumper on CSEL. When the CSEL signal of the interface connector is set low, the drive is designated as Drive 0. when the CSEL is set high , the drive is designated as Drive 1. Consult your PC manufacturer, IDE Card manufacturer or dealer for further details. 1 If your computer has its rear side covered by a plastic panel Attached with plastic hook pad, pull it off. If mounting rails are necessary, attach them to the drive in the same way as your floppy disk drive and slide the drive into the lower drive bay. If mounting rails are not required in your system, screw the drive in place. Connect the drive to the computer with the following connectors: · After matching the beveled edges, insert the plug of the power supply cable to the DC INPUT connector and push it firmly in place. S Frame ground When normally installed, the drive unit is not in contact with the host computer directly and should be grounded. Connect the frame ground tab to one of the host computer's ground cables. Refer to the operating instructions included with the host adapter for complete instructions on installation and settings. 1 Replace the cover on the computer, being careful to reinstall all 2 Replace the AC power cord and turn on your computer. MSCDEX and the device driver for an ordinary CD-ROM drive can be used when using the CRX100E as a CD-ROM drive. Use the device driver for a CD-R/RW drive when using the CRX100E as a recordable or rewritable drive. Be sure to install the device driver before operating the drive. [. . . ] When the drive's right side is down To facilitate disc handling, set the disc locks B, C and D into the locked position, and leave the disc lock A in the unlocked position. When the drive's left side is down To facilitate disc handling, set the disc locks A, C and D into the locked position, and leave the disc lock B in the unlocked position. S General Host interface Read Function Acceptable discs: ATAPI compliant CD-ROM mode-1 data discs CD-ROM XA discs CD-Audio discs Audio-combined CD-ROM discs CD-I discs CD-I Ready Discs Photo CD (Single and Multi session)discs Video CD discs CD-EXTRA discs CD-TEXT discs CD-R discs (Conforming to "Orange Book Part II") CD-RW discs (Conforming to "Orange Book Part III") CD-ROM Mode-1 CD-ROM XA CD-Audio Audio-combined CD-ROM CD-I Video CD CD-EXTRA CD-TEXT Disc at once Session at once Track at once Variable packet writing (Packet size : max. 1 Mbyte) Fixed packet writing (Packet size : max. [. . . ]