User manual SONY CRX-100EX

[. . . ] Writing speed may automatically be adjusted depending on the disc specified speed or disc conditions such as weight imbalance and eccentricity. 1× and 2× writing speed and discs are not supported. Quick Start Guide Software Quick Start Guide Electronic manual on the software disc Warranty cards Product Information (this document) This CD-RW drive can be used in systems with the following capabilities. CPU: Pentium 266 MHz or higher For stable writing performance at high speeds, the CPU speed should be considerably higher than the above minimum requirement. [. . . ] CPU: Pentium 266 MHz or higher For stable writing performance at high speeds, the CPU speed should be considerably higher than the above minimum requirement. For writing at 52× speed, a Pentium II/400 MHz or higher is recommended. PC/AT-compatible PC OS: Windows® 98 Second Edition Windows® 2000 Professional Windows® Millennium Edition Windows® XP Home Edition Windows® XP Professional At least 32 MB RAM (64 MB or higher recommended) At least 1 GB available hard disk space One available EIDE (ATAPI) interface connection with DMA capability One empty 5-inch half-height drive bay One available internal +12 V/+5 V power connector notes · The above system configuration is given as a minimum requirement for a system on which basic CD-RW writing performance can be obtained. In actual use, the requirements for the writing software and "Windows" also have to be taken into consideration. (Normally, these requirements will be higher than the above specifications. ) · The drive cannot be assured to operate properly if connected to an ATAPI interface adapter card (we cannot guarantee compatibility or offer user support). This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. cAUTION · On rare occasions, some discs may not be able to tolerate 52× speed, causing them to break. We recommend that you do not use deeply scratched, brittle, or other discs that may break at 52× speed. The Turbo Boost function does not increase read/write speed with CD-RW discs. notes · When you want to write at 52× speed, insert the disc into the drive, activate the Turbo Boost function, and then start writing to the disc. When writing with the Turbo Boost function, the Busy indicator blinks more rapidly than usual. (About twice as fast as when writing at the default write speed. ) · When you open the disc tray, the speed reverts to its default of 40× speed. The Turbo Boost function does not guarantee a 52× write speed. Depending on the condition of the disc you are using, the speed may be lower. The Busy indicator blinks twice and the speed switches to 52× speed. [. . . ] Depending on the condition of the disc you are using, the speed may be lower. The Busy indicator blinks twice and the speed switches to 52× speed. Local technical support service is available only in the following sales regions: Free telephone support is offered for 90 days from your first call. Product purchased in Canada (Sony of Canada Limited): 24 hours / 7 days a week · Before using this device, be sure to read the end-user license agreements for the software provided with your computer. [. . . ]