User manual SONY CRX-320E

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. If you have any questions about this product, you may call the telephone number listed in the "Product and Support Information" section. The telephone number below is not for customer service, but for official purposes only. [. . . ] 5 in) CAUTION Depending on the product you are using, the Emergency Eject Hole may be in a different location than illustrated above. This product offers the following features. With the Turbo Boost function, easily switch from the default 40× read/write speed to 52× speed. "Power-Burn conformed" is used to refer to a CD-R/RW that uses CD-R/RW recording technology (ICs and/or firmware) other than Power-Burn, but provides performance equivalent to that of Sony original Power-Burn technology based on the Power-Burn concept. notes · Writing speed may automatically be adjusted depending on the disc specified speed or disc conditions such as weight imbalance and eccentricity. 1× and 2× writing speed and discs are not supported. During startup, the drive may make a whirring noise due to balls contained in the ABS (Auto-Balance System) spindle motor. This is normal and does not indicate a drive malfunction. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. When you use this unit as an audio CD player, please use compact discs with the following mark. This CD-RW/DVD-ROM drive can be used in systems with the following capabilities. cPU: Pentium II 400 MHz or higher is recommended. PC/AT-compatible PC OS: Windows® 98 Second Edition Windows® 2000 Professional Windows® Millennium Edition Windows® XP Home Edition Windows® XP Professional 64 MB RAM or higher is recommended At least 1 GB available hard disk space One available EIDE (ATAPI) interface connection with DMA capability One empty 5-inch half-height drive bay One available internal +12 V/+5 V power connector notes · The above system configuration is given as a minimum requirement for a system on which basic CD-RW writing performance can be obtained. In actual use, the requirements for the writing software and "Windows" also have to be taken into consideration. (Normally, these requirements will be higher than the above specifications. ) · The drive cannot be assured to operate properly if connected to an ATAPI interface adapter card (we cannot guarantee compatibility or offer user support). Please note that specifications and appearance may be subject to change without notice. [. . . ] Depending on the condition of the disc you are using, the speed may be lower. Please consult the above sources before calling with questions about using this product, or with technical questions about the drive or the supplied software. If using telephone or e-mail support, please have the following information available: · Computer specifications (CPU speed, memory size, OS version, etc. ) · Writing software used (version, etc. [. . . ]