User manual SONY CSD760E

[. . . ] All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN "CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. " Warning To prevent electric shock or injury, these safety instructions should be followed in the installation, use and servicing the unit. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Installation Attachments ­ Do not use attachments not recommended by the unit manufacturer as they may result in the risk of fire, electric shock or injury to persons. Water and Moisture ­ Do not use this unit near water - for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like. [. . . ] Disconnect the AC cord. Notes on batteries To avoid damage from leakage or explosion, observe the following: · Insert the batteries with the 0 and 9 marks correctly aligned. · Do not mix different types of batteries or old batteries with new ones. · When the unit is not to be used for a long period, remove the batteries. · Never recharge the batteries, apply heat to them or take them apart. If liquid leaks from the batteries, wipe thoroughly to remove. CAUTION Use only the supplied AC cord. Use with other cords may result in the risk of fire. Maintenance To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner. After every 10 hours of use, clean the tape heads with a head cleaning cassette. Use separately sold dry-type or wet-type cleaning cassette. Refer to the instructions of the cleaning cassette for details. To clean the heads When the tape heads are dirty; - high frequency sound is not emitted - the sound is not adequately high - the sound is off-balance - the tape cannot be erased - the tape cannot be recorded on To clean the lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge. Lens 4 ENGLISH Remote control (CSD-TD49 only) Insert two R6 (size AA) batteries. Specifications Tuner section Frequency range, antenna ­ FM: 87. 5 - 108. 0 MHz Rod antenna, AM: 530/531 - 1, 710/1, 602 kHz (10/9 kHz step) Ferrite bar antenna Deck section Track format ­ 4 tracks, 2 channels / Frequency range ­ Normal tape: 50 - 12, 500 Hz (EIAJ) / Recording system ­ AC bias / Erasing system ­ AC erase / Heads ­ Recording/playback head (1), Erasure head (1) R6 (AA) When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries. CD player section Disc ­ Compact disc / Scanning method ­ Non-contact optical scanner (semiconductor laser) The remote control may not operate correctly when: - The unit is exposed to intense light, such as direct sunlight - Objects block the remote control signal to the unit General Speaker ­ 80 mm cone type (2) / Output ­ Headphones jack (stereo mini-jack) / Power output ­ 2. 5 W + 2. 5 W (EIAJ, 7 ohms, THD 10% DC) / Power requirements ­ DC 12 V using eight size C (R14) batteries, AC 120 V, 60 Hz / Power consumption ­ 16 W / Dimensions (W × H × D) ­ 306 × 155 × 253 mm (12 1/8 × 6 1/8 × 10 in. ) / Weight (excluding batteries) ­ 2. 5 kg (5 lbs. · Pressing DISPLAY on the remote control displays the adjusted volume level (CSD-TD49 only). 3-MODE EQ * (equalizer) PRESETTING STATIONS You can preset up to 15 stations in each band. 1 2 Select a station. Place a disc with the printed side up and close the disc compartment. PUSH OPEN Total number of tracks and total playing time are displayed. It will take about 15 seconds when loading a CD-RW disc. NOTE · Do not use irregular shape CDs (example: heartshaped, octagonal ones). · Do not place more than one disc in the disc compartment. · Do not try to open the disc compartment during play. · The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms. · Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. · Do not load an unrecorded CD-R/RW disc. It will take over 30 seconds to read the disc. The disc may be damaged if you try to open the disc compartment while reading the disc. 3 Press e PLAY/PAUSE to start play. The number of the track being played and elapsed playing time are displayed. s STOP/SET/CLEAR * ­ Stops play. * or s STOP on the remote control (CSD-TD49 only) e PLAY/PAUSE ­ Pauses play. [. . . ] When the selected function is CD, CD play and recording starts simultaneously. Simple sleep timer setting Press REPEAT/MODE/SLEEP while the power is off. The unit is turned on with the last function, and the sleep timer is automatically turned on with the 30-minute setting. Select the function, if you need, and start playback. To record only the selected tracks of a CD 1 Follow steps 1 to 4 of PROGRAMMED PLAY on page 9 to program tracks. To pause recording (only when the source is RADIO), press e. [. . . ]