User manual SONY CSDFD91

[. . . ] All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN "CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. " Installation 1 Water and moisture - Do not use this unit near water, such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, swimming pool, or the like. 2 Heat - Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41°F) or greater than 35°C (95°F). [. . . ] To turn off the demo, press * DISPLAY/COLOR/DEMO. You can turn it on or off by pressing DISPLAY/COLOR/ DEMO while the power is off. * or DISPLAY on the remote control · When using the unit on the batteries, the demo is not displayed. · For ordinary use, turn off the demo to save power consumption. Changing the display color You can select the color of the display light: orange, blue, purple (or turned off). Press * DISPLAY/COLOR/DEMO repeatedly while the power is on. * or DISPLAY on the remote control · When using the unit on the batteries, the display light is off. Illuminations on the front panel (CSD-FD92 only) The illuminations light up or flash while the power is on. In playback mode, they will show the approximate sound level. To turn off the illuminations, hold down * DISPLAY/ COLOR/DEMO while the power is on. * or DISPLAY on the remote control · When using the unit on the batteries, the illuminations are off. 4 ENGLISH Remote control Insert two R6 (size AA) batteries. R6 (AA) When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries. The remote control may not operate correctly when: - The unit is exposed to intense light, such as direct sunlight - Objects block the remote control signal to the unit To use the buttons on the remote control Buttons on the remote control and the main unit with identical indications have the same functions. To turn the power on Press POWER to turn on the display. When using the unit on the batteries, this button will not turn the power on. En To turn the power off Press POWER to turn off the display. To use the FUNCTION button Each time FUNCTION is pressed while the power is on, the function is selected cyclically. CD TAPE TUNER Maintenance To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution. Jazz - Emphasizes the low range of music. * or EQ on the remote control PRESETTING STATIONS You can preset up to 15 stations in each band. 1 2 Select a station. Press * a PAUSE/SET once so that "M" is displayed to store the station. A station is assigned a preset number, beginning from 1 in consecutive order for each band. Preset number T-BASS system The T-BASS system enhances the realism of lowfrequency sound. Press T-BASS to turn it on or off. QSOUND system This system provides a rich, three dimensional sound area for stereo sources. Press QSOUND and the QSOUND indicator lights up. · At higher volumes, turning QSOUND on may cause sound distortion. · Do not load an unrecorded CD-R/RW disc. It will take over 30 seconds to read the disc. The disc may be damaged if you try to open the disc compartment while reading the disc. 3 Press d PLAY/DIR/PRESET (c PLAY/ PRESET) to start play. The number of the track being played and elapsed playing time are displayed. s STOP/CLEAR ­ Stops play. r, t ­ Searches for a particular point during playback. [. . . ] · CSD-FD82 plays (records on) the side facing up. PLAYBACK 1 2 Press TAPE. The power is turned on. If the tape has been inserted, play begins. Press PUSH EJECT to open the cassette holder and insert a tape with the side to be played facing up and the exposed side facing forward. RECORDING 1 PUSH EJECT Insert a tape with the side to be recorded on facing up and the exposed side facing forward. For CSD-FD92, press REPEAT/MODE/SLEEP to select the reverse mode. Check that is displayed, so as to start recording from the side facing up. Press PUSH EJECT to close. 3 Press d PLAY/DIR/PRESET (c PLAY/ PRESET) to start playback. 2 3 Get ready to record from the source. To record from a CD, press CD and load the disc. To record from a radio broadcast, press TUNER/ BAND and tune to a station. Tape counter To set the tape counter to "0000" Press s in stop mode. [. . . ]