User manual SONY CTX408

[. . . ] -- Connect the equipment into an outlet on circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. PRECAUTIONS This unit is designed to be operated on a 12-volt DC negative-ground electrical system only, q To prevent short-circuiting, disconnect the negative car battery terminal until the unit has been mounted and connected completely. q When replacing the fuse, be sure to use one whose amperage rating is identical. Use of a fuse of higher amperage may cause serious damage to the unit. [. . . ] This lamp is designed to deter theft, and continues to flash when the car's ignition is turned off with the front panel detached. This unit is not equipped with any other security systems such as a security alarm, sothereare Iimitationsto its effectiveness. 1 2 Press PWR to turn the unit off. While supporting the front panel with one hand, press ~ to release one aide of the panel. Care must be taken not to drop the panel. When the front panel is lifted from the unit, remove it by pulling it away from the unit. 3 LEOIsmp Do NOT touch the connector on the reverse side of the front panel, as doing so may contaminate the connector and cause a poor connection resulting in a malfunction. ENGLISH 4 SETTING THE BEEP TONE The unit is preset at the factory to beep each time you press any button on the front panel except OPEN. You can stop beeping by following the procedure below. SETTING THE CLOCK 1 3 2;4 [@cl 1 -i EKIl 1 2 Press PWR. Press and hold down DISP for more than 1. 5 seconds until the clock indication flashes. q With the unit off, press 1 and 4 at the same time. The "BEEP indication appears. Each time you press them, this function turns on or off. The beep function is activated when the "BEEP indication appears with the audio control indicator lighting up and deactivated without the indicator. If you do not proceed with step 3 within 5 seconds, the clock indication disappears. 3 4 Ez!mEl Press V to set the hour. Press DISP to stert working the clock from O second. Audio control indicator Havingthe clockdisulayed while in Radio, Tape Playo; CD Changar Play mode Press DISP. To return the unit to its former display, repeat the same procedure. 5 ENGLISH RADIO OPERATION 1 32 PWR TUNE VIA LO 4 1 2 Press PWR to turn the unit on. Press BAND to select the band from among FM1, FM2, FM3 and AM. The band indication appears cyclically in order. (FM1, FM2 and FM3 share the same frequency range. ) Band indication Frequency indication I LO (local/DX) button You can use Local mode when you wish to tune in only strong stations during seek tuning. In Radio mode, press LO to select Local mode. q Press LO to deactivate Local mode and switch to DX (distance) mode. q The "ST" (stereo) indicator lights up when the tuned-in station is broadcasting in stereo and the reception is good. I 1 3 Press (more than 0. 5 second) either TUNE 7 orTUNE Atotuneinthedeaired station. Press Y to decrease and A to increase the frequency. The unit starts scaning and tunes in a station automatically (Seek tuning). Press the button again to deactivate Seek tuning. Repeattheprocedure until the desired station is tuned in. Note If you press (less than 0. 5 second at a time) either TUNE Y or TUNE A, the frequency decreases or increases step by step. 4 Adjust the volume with +/-. To turn the unit off Press PWR, Switching modes When the unit is in Radio mode, inserting a cassette switches the unit to Tape Play mode automatically. ENGLISH 6 PRESETTING STATIONS hT 1 Press BAND to selects desired bend from among FMI, FM2, FM3 and AM. Press BAND to select the band from among FM1, FM2, FM3 and AM. Tune in the station that you wish to preset with TUNE Y or TUNE A. [. . . ] Turnoffyour CD changer system. To turnthe unitoff Press PWR. 3 4 q For further information on the connected equipment, refer to the operating instructions for the equipment. Nota Be sure to press CD IN after you connect a portable CD player, etc. to the CD IN jack to listen using the connected equipment. Even if equipment isconnectedtothe CD IN jack, you cannot listen using me connected equipment without switching the unit to CD IN mode by pressing CD IN. i I i3VGf/S/f MAINTENANCE Cleaningthe frontpanel When the frontpanelis soiled, wipethe surface of the panelwitha dryand softcloth. Cleaningthe tapehead Use a cleaningcassetteto clean the playback headandcapstans approximately oncea month. [. . . ]