User manual SONY CVPG500

[. . . ] ⷠBe sure to insulate any loose unconnected leads with electrical tape for safety. Notes on the power supply lead (yellow) · When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. ⷠWhen no car circuits are rated high enough, connect the unit directly to the battery. Be sure to connect the earth lead before connecting the amplifier. [. . . ] Be sure to connect the earth lead before connecting the amplifier. Connecting any other system may damage the unit. If you have a power aerial without a relay box, connecting this unit with the supplied power connecting lead may damage the aerial. notes on the control and power supply leads · The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner. ⷠWhen your car has built-in FM/AM aerial in the rear/side glass, connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. A power aerial without a relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. ⷠUse speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities to avoid its damage. ⷠDo not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. You may need to switch the positions of the red and yellow leads in the car stereo's power connecting lead. After matching the connections and switched power supply leads correctly, connect the unit to the car's power supply. If you have any questions and problems connecting your unit that are not covered in this manual, please consult the car dealer. Before installing the unit, remove the protection collar and the bracket from the unit. Engage the release keys together with the protection collar . Pull out the release keys to remove the protection collar . Insert both release keys together between the unit and the bracket until they click. Pull down the bracket , then pull up the unit to separate. Bend these claws outward for a tight fit, if necessary (-2). ⷠMake sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). [. . . ] Bend these claws outward for a tight fit, if necessary (-2). ⷠMake sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). You may not be able to install this unit in some makes of Japanese cars. How to detach and attach the front panel () Before installing the unit, detach the front panel. [. . . ]