User manual SONY CXLEC10

[. . . ] CD Stereo System XR-EC10 XR-EC12 U C Owner's record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. (Lot No. ) OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) For assistance and information (United States and Puerto Rico) 8C-CL3-903-01 020301ASW-H-M WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. [. . . ] To change the display in playback mode Press DISPLAY during play. The display changes in the following order: Track number being played and elapsed playing time Remaining time of play ·Remaining time of play cannot be displayed during " 1, random or programmed play. s E 0­10, +10 RANDOM/ REPEAT E s DISC DIRECT PLAY f, g En DISPLAY f, g PROGRAM zOPEN/ CLOSE DISPLAY DISC DIRECT PLAY SHIFT This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing CDs 1 Press CD1 zOPEN/CLOSE to open the disc tray. Place a disc with the label side up. ·When loading an 8-cm disc, place it on the inner circle of the tray. 2 To play two or three discs, load the second and third discs in disc tray 2 and 3, using CD2 and CD3 zOPEN/CLOSE respectively. Finally, close the disc tray by pressing zOPEN/CLOSE. After reading the loaded disc, " " lights up at the corresponding disc number 1-3 in the display. The corresponding DISC DIRECT PLAY (CD1/CD2/CD3) also lights up. 3 Press E to play all the discs. Play starts from the currently selected disc (j lights up by the selected disc number in the display). To play a single disc (single disc play) Press the desired DISC DIRECT PLAY (CD1/CD2/CD3). Only the selected disc number lights up in the display. Pressing the DISC DIRECT PLAY repeatedly during play changes the playback mode as follows. Single disc play Y All disc play zOPEN/CLOSE Disc tray number 8 Random/Repeat play In random play mode the unit plays all the tracks in random order. In repeat play mode it plays repeatedly all the discs or the track being played. You can select random and repeat all play at the same time. 1 Press RANDOM/REPEAT repeatedly on the remote control. The mode changes as follows: "" 1": Plays one track repeatedly. """: Plays all the tracks repeatedly. "RANDOM": Plays all the tracks randomly. "RANDOM " ": Plays all the tracks repeatedly in random order. Programmed play Up to 30 tracks can be programmed from any of the loaded discs. 1 Press PROGRAM on the remote control in stop mode. "PRGM" flashes on the display. To check the program Press f or g repeatedly in stop mode. The track number and program number are displayed in succession. To clear the program Press s in stop mode. "PRGM" disappears from the display. To add tracks to the program Repeat step 2 before starting playback. The tracks are added to the end of the program. To change the programmed tracks Clear the program and repeat all the steps again. Notes on CDs 2 Press one of DISC DIRECT PLAY (CD1/CD2/CD3) to select a disc. Wait for a while until the disc tray is selected. En 3 Press the numbered buttons on the remote control to program a track. -To select the 25th track, press +10, +10 and 5. -To select the 11th track, press +10 and 1. The selected track number lights up on the display. 2 To play all discs: press E. [. . . ] (See "Resetting the unit". ) 2 Press CD2 zOPEN/CLOSE to open the disc tray. 3 Disconnect the AC power cord from the AC outlet. 4 Attach the protective tag as illustrated. En Troubleshooting If your unit fails to perform properly, check the following guide and the relevant sections of the Operating Instructions. There is no sound ·Are the speakers and AC power cord connected properly?The unit shut off suddenly ·Possibly a short circuit in the speaker terminals. [. . . ]