User manual SONY CXLEM20

[. . . ] CD Stereo System XR-EM20 U C Owner's record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. (Lot No. ) OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) For assistance and information (United States and Puerto Rico) 8C-CL7-903-01 011228ACK-H-BF WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. IMPORTANT SAFETY INSTRUCTIONS Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. [. . . ] 2 Press s, then press SET on the remote control within 6 seconds. Preset station numbers in the band which are higher than the cleared number decrease by one. 0­10, +10 s SET SHIFT PRESET +, TUNER/BAND f, g En f, g Manual tuning 1 Press TUNER/AUX/BAND (TUNER/BAND on the remote control) repeatedly to select a band. 2 Press f or g repeatedly to tune in a station. "TUNE" is displayed when a station is tuned in. "1" is displayed for FM stereo reception. To search for a station automatically (Auto search) Hold down f or g. The unit searches for a station and stops at reception. To stop the search manually, press f or g. ·Auto search may not stop at stations with weak signals. Preset tuning Preset up to 32 of your favourite stations and tune them in directly. Presetting stations 1 Tune in the desired station. 2 Press SET on the remote control to store the station. The preset number, beginning from "1" flashes on the display. 3 Repeat steps 1 and 2 to preset other stations. The next station will not be stored if a total of 32 preset stations have already been stored. ("FULL" is displayed. ) ·If power is interrupted for more than approximately 12 hours, all settings stored in memory after purchase need to be reset. 10 SOUND ADJUSTMENTS Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that "MONO" is displayed. To cancel, repeat the above so that "STEREO" is displayed. VOLUME TONE Tip: When FM stereo reception is poor, switching to monaural reduces noise. To switch the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Hold down TUNER/AUX/BAND and press POWER on the main unit. En VOLUME +, TONE Tip: When the AM tuning interval is changed, all preset stations are cleared. Volume Turn VOLUME (press VOLUME +, - on the remote control). Adjust from 0 (minimum) to 30 and MAX (maximum). Bass and treble 1 Press TONE repeatedly to display "BAS" or "TRE". "BAS" : Adjusts the bass level "TRE" : Adjusts the treble level Tip: Volume level setting is retained during power-off standby. If the unit is turned off with the volume set to 17 or higher, it is automatically turned down to 16 the next time the unit is turned on. 2 Within 6 seconds, turn VOLUME (press VOLUME +, - on the remote control). Each level can be adjusted from "­2" to "+5". ·If the sound becomes distorted, lower the level. 11 TAPE PLAYBACK Notes on cassettes TUNER MODE FUNCTION c REC/ REC PAUSE REC MUTE ·Use of 120-minute or longer tapes is not recommended since they are extremely thin and easily deformed or damaged. ·Wind up any slack in the tape with a pencil or similar tool before use. Slack tape may jam in the mechanism. En REC/ REC PAUSE SYNCHRO REC s s c f, g zPUSH EJECT f, g SHIFT Playback Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. 2 Insert the tape. Insert with the exposed side down and the side to be played facing out from the unit, and press zPUSH EJECT to close the cassette holder. To stop playback Press s. To reset the tape counter Press s in stop mode, and the tape counter on the display is reset to "0000". Opening and closing the cassette holder will also reset the tape counter. To eject the tape Press zPUSH EJECT after the deck stops completely. 3 Press c to start play. 12 TAPE RECORDING Basic recording Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. [. . . ] ·Is the lens affected by condensation?If so, wait approximately one hour and try again. En Condensation Moisture may form on the CD pickup lens when: ·The unit is moved from a cold spot to a warm spot ·The heating system has just been turned on ·The unit is used in a very humid room ·The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. Resetting the unit If an unusual condition occurs in the display window or the cassette deck, reset the unit as follows: 1 Press POWER to turn off the power. If the power cannot be turned off, disconnect the AC power cord, then plug it in again. [. . . ]