User manual SONY CXLEM70

[. . . ] All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. Ventilation - The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm clearance from the rear and the top of the unit, and 5 cm from the each side. Slots and openings in the cabinet and the back or bottom are provided for ventilation, and to ensure reliable operation of the unit and to protect it from overheating, these openings must not be blocked or covered. [. . . ] 9 PRESET +, 0 DISC DIRECT PLAY 1, 2, 3 !f/r, t/g @ VOLUME +, # TIMER Selects timer mode. SLEEP Selects sleep-timer mode. En 2 3 4 5 6 7 9 0 !@ # 3 RANDOM/REPEAT Selects random or repeat CD playback mode. PROGRAM Selects programmed CD playback mode. 4 ECD AUX TONE Selects the sound adjusting mode, "BAS" (bass) or "TRE" (treble). TUNER/BAND sCLEAR 5 SET 6 DISPLAY 7 SHIFT Hold down when pressing a numbered button to change its function to that printed above the number. Buttons with the same or similar names on the main unit basically have the same function. 1 POWER 2 0­10, +10 CD: selects a track of the specified number. Radio: tunes in the station with the specified preset number. 6 ADJUSTMENTS BEFORE OPERATION When operating while the power is on POWER POWER 6STANDBY/ON CD f, g DISC DIRECT PLAY SET CD, AUX TUNER/BAND f, g 1 Press ECO/DIMMER once and press SET. 2 Within 6 seconds, press f or g to select the desired mode and press SET. Standby power consumption ECO ON: 0. 6 W ECO OFF: 16 W En DISC DIRECT PLAY SET TUNER/ BAND, AUX Dimmer The display window brightness can be adjusted to the following four levels: "DIM OFF", "DIMMER 1", "DIMMER 2", and "DIMMER 3". "DIM OFF" is the brightest level. When "DIMMER 3" is selected, the display is darkest. 1 Press ECO/DIMMER twice while the unit is turned on. "DIM MODE" is displayed. Power Turning the unit on Press POWER 6 STANDBY/ON (POWER on the remote control). To play a single disc: press the desired DISC DIRECT PLAY (CD1/CD2/CD3). To cancel random/repeat play Press RANDOM/REPEAT on the remote control repeatedly until "RANDOM" or """ disappears. Direct selection of the tracks with the numbered buttons cancels random play mode. To repeat a selected set of tracks First select the tracks with programmed play (see "Programmed play"). Then select repeat playback. 4 Repeat steps 2 and 3 to program other tracks. The total number of selected tracks and total playing time will be displayed. 5 Press E. ·During programmed play, you cannot select a track with the numbered buttons. "Can't USE" is displayed when you try to select a track . ·If the total playing time of the program exceeds 99 minutes and 59 seconds, or if a track with a track number exceeding 30 is programmed, the playing time is displayed as "- - : - -". ·You cannot program more than 30 tracks. "FULL" is displayed. ·Do not place more than one disc. ·Do not tilt the unit with a disc loaded. ·The unit may not play CD-R/RW discs recorded on personal computers or certain kinds of CD-R/RW recorders. ·Do not attach adhesive label to either side of CD-R/RW discs, as doing so may cause malfunction. [. . . ] Everything stored in memory after purchase is cleared. When transporting the unit with packing materials When transporting the unit using the packing materials, for example, when asking for repair, be sure to re-attach the protective tag, which was attached when you purchased the unit, before packing the unit. Re-attach the protective tag as described below. 1 Reset the unit while the unit is turned off. [. . . ]