User manual SONY CXLMG9

[. . . ] Compact Disc Stereo System XR-MG9 U OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) For assistance and information (United States and Puerto Rico) 8B-CLR-903-01 010601AYK-H-B PRECAUTIONS WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. CAUTION Read these Operating Instructions carefully and completely before operating the unit. All precautions in this booklet and on the unit should be strictly followed. Keep the Operating Instructions for future reference. Installation 1 Water and moisture -- Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like. [. . . ] Radio: displays the frequency of the tuned station and current volume level. TIMER Selects timer playback setting mode. En Buttons with the same or similar names on the main unit basically have the same function. 1 0­10, +10 CD: selects a track of the specified number. Radio: tunes in the station with the specified preset number. SLEEP Selects sleep-timer setting mode. TUNER MONO Switches between stereo or monaural FM reception. - ROCK: Powerful sound emphasizing treble and bass - POP: More presence in the vocals and midrange - JAZZ: Accented lower frequencies for jazz-type music - EQ OFF: Equalizer effect is canceled. Q SURROUND system The Q SURROUND system built into this unit uses only two speakers at the left and right to create an atmosphere that sounds as if you are surrounded by two front speakers and two rear speakers. Hold down SHIFT and press EQ/QSURROUND on the remote control. "ON QSURROUND" will flow from right to left. To cancel the Q SURROUND effect "OFF QSURROUND" flows from right to left and the "QSURROUND" indicator goes off. 2 Press f or g to set the time. Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units. If f or g is not pressed within 4 seconds, setting is canceled. En T-BASS Emphasizes low frequencies for a powerful sound. Press T-BASS repeatedly to select one of the three emphasis levels or the off position. ·If the sound becomes distorted with the T-BASS effect, cancel the effect. 3 Press a or ENTER. The time display stops flashing and the clock starts from 00 seconds. To display the time while the power is on Hold down SHIFT and press CLOCK on the remote control. The time will be displayed for 4 seconds. To switch to the 24-hour standard Display the time and press s within 4 seconds. With each press, the clock alternates between 12- and 24hour standard time. Tips: ·The Q SURROUND system does not work in monaural mode. ·When the Q SURROUND system is on, the sound may be distorted at higher volumes. If this happens, turn the volume down. Tip: In the 12-hour standard, "AM12:00" indicates midnight and "PM12:00" noon. If the clock display flashes when the unit is turned off There has been a power interruption. Reset the clock. 9 CD OPERATIONS f, g VOLUME UP/ DOWN as c RANDOM/ REPEAT DISPLAY PROGRAM 0-10, +10 CD Random/Repeat playback Random playback plays all the tracks in random order. Repeat playback plays all the tracks or the track being played repeatedly. You can select random and repeat all playback at the same time. 1 Hold down SHIFT and press RANDOM/REPEAT on the remote control repeatedly to select one of the following modes: Repeat 1 playback: "" 1" Repeat all playback: """ Random playback: "RANDOM" Random/Repeat all playback: "RANDOM "" 2 Press c to start play. To cancel random/repeat playback Hold down SHIFT and press RANDOM/REPEAT on the remote control repeatedly until "RANDOM", "" 1" or "" " disappears. Direct selection of the tracks with the numbered buttons cancels the random mode. To repeat a selected set of tracks First select the tracks with programmed playback. [. . . ] The unit shut off suddenly ·Possibly a short circuit in the speaker terminals. Disconnect the AC power cord from the AC outlet and reconnect the speaker cords correctly. All the display lights turn off when the power is off ·Is ECO mode set to on?Erroneous display ·Reset the unit. 8 Press POWER 6STANDBY/ON to turn the unit off. "5" remains on the display to indicate the timer standby mode (when the ECO mode is deactivated). [. . . ]