User manual SONY CXLX7

[. . . ] Compact Disc Stereo System XR-X7 U C OPERATING INSTRUCTIONS En (English) MANUAL DE INSTRUCCIONES E (Español) MODE D'EMPLOI F (Français) For assistance and information (United States and Puerto Rico) 8B-CL2-903-21 010620CYK-H-M PRECAUTIONS WARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. CAUTION Read these Operating Instructions carefully and completely before operating the unit. All precautions in this booklet and on the unit should be strictly followed. Keep the Operating Instructions for future reference. Installation 1 Water and moisture -- Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like. [. . . ] 7 Press ENTER. 3 Press a or ENTER. The time display stops flashing and the clock starts from 00 seconds. To display the time while the power is on Hold down SHIFT and press CLOCK on the remote control. The time will be displayed for 4 seconds. To switch to the 24-hour standard Display the time and press s within 4 seconds. With each press, the clock alternates between 12- and 24hour standard time. 5 Press COLOR. 6 Turn VOLUME/MULTI JOG to adjust the color. The level can be adjusted from "00" to "50". "50" is the brightest level. Changing the color mode 1 Hold down COLOR until "F-CL" is displayed. 2 Within 4 seconds, turn VOLUME/MULTI JOG to select "F-CL ON" or "F-CL OFF". - F-CL ON: function color mode - F-CL OFF: select color mode 7 Press COLOR. 8 Repeat steps 4 to 7 to set the desired color. 9 Press ENTER. ·If power is interrupted for more than approximately 12 hours, all settings stored in memory after purchase need to be reset. ·If you select "00" in each color, it displays no color on the display. ·The display color may not change when you adjust only one of the colors. Tip: In the 12-hour standard, "AM12:00" indicates midnight and "PM12:00" noon. If the clock display flashes when the unit is turned off There has been a power interruption. Reset the clock. 3 Press ENTER. If there is no operation for 4 seconds, setting is canceled. 9 CD OPERATIONS cPRESET sCLEAR zOPEN/CLOSE f, g aSET CD RANDOM/ REPEAT DISPLAY PROGRAM 0-9, +10 CD SHIFT f, g cPRESET aSET sCLEAR VOLUME (N, M) To select a track with the remote control (Direct play) Press the numbered buttons to select a track. - To select track 25, press +10, +10 and 5. To change the display in playback mode Press DISPLAY (hold down SHIFT and press DISPLAY on the remote control) during play. The display changes in the following order: 1 Track number being played and elapsed playing time 2 Remaining time of play ·Remaining time of play cannot be displayed during random play or programmed play. En DISPLAY VOLUME/MULTI JOG This unit plays back finalized CD-R/RW discs as well as audio CDs. 3 Press c to start play. To stop play Press s. To skip to the beginning of the current/preceding/ succeeding track Press f or g repeatedly. To search (playing in fast forward or reverse) Hold down f or g. Release at the desired point. Playing a CD 1 Press CD to select the CD function. 2 Press z OPEN/CLOSE to open the disc compartment. Place a disc with the label side up. Then close the disc compartment. Pivot zOPEN/CLOSE To remove the disc Press zOPEN/CLOSE in stop mode to open the disc compartment. Then pull out the disc while pressing the center pivot. 10 Random/Repeat play In random play mode the unit plays all the tracks in random order. [. . . ] If the power cannot be turned off, disconnect the AC power cord, then plug it in again. 2 Hold down s and press POWER on the main unit. Everything stored in memory after purchase is cleared. En Troubleshooting If your unit fails to perform properly, check the following guide and the relevant sections of this manual. There is no sound ·Are the speakers and AC power cord connected properly?The unit shut off suddenly ·Possibly a short circuit in the speaker terminals. [. . . ]