User manual SONY CXNAJ17

[. . . ] Please refer to them when you contact your Aiwa dealer in case of difficulty. (Lot No. ) SX-NA54 SX-R210 (NSX-A54 only) PRECAUTIONS Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. [. . . ] 4 Press the z REC/REC MUTE button to start recording. When the selected function is CD, playback and recording start simultaneously. (Applicable when the source is TUNER, VIDEO/AUX or MD. ) To resume recording, press again. INSERTING BLANK SPACES Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER, VIDEO/AUX or MD. ) 1 Press the z REC/REC MUTE button during recording or while in recording pause mode. on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode. To insert a blank space of less than 4 seconds, press the z REC/REC MUTE button again while is flashing. To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the z REC/REC MUTE button again. Each time the button is pressed, a 4-second blank space is added. To erase a recording Make sure the microphone is not connected to this unit. 1 Insert the tape to be erased into deck 2 and press the TAPE/DECK 1/2 button to display "TP 2". 2 Set the tape to the point where the erasure is to be started. (AI: Artificial Intelligence) NOTE AI edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of either side. Insert the tape with the side to be recorded on first facing out from the unit. 2 Press the CD button and load the disc(s). "EDIT" lights up and AI edit flashes on the display. Each time it is pressed, the display changes as follows. To select with the remote control, press the EDIT/CHECK button while pressing the SHIFT button. 4 Press one of the DISC DIRECT PLAY buttons to select a disc. 5 Press the or button to designate the tape length. In a few seconds, the microcomputer determines the tracks to be recorded on each side of the tape. · The numbered buttons on the remote control are also available to designate the tape length. Example: When using a 60 minute tape, press the 6 and 0 buttons. 6 Press the z REC/REC MUTE button to start recording. The tape is rewound to the beginning of the front side, the lead segment is played through for 10 seconds, and recording starts. [. . . ] The reception contains noise interference or the sound is distorted. · Is the system picking up external noise or multipath distortion? Move the unit away from other electrical appliances CASSETTE DECK STATION The tape does not run. ( page 11) The sound is off-balance or not adequately high. [. . . ]