User manual SONY D-E999

[. . . ] Owner's Record The model number is located at the rear and the serial number is located inside the lid of the CD player. Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. ___________________ Certain countries may regulate disposal of the battery used to power this product. [. . . ] "00" appears and the playing order increases by one. 4 5 Repeat steps 2 and 3 to select the tracks in your favorite order. Press the jog lever toward u to start the PGM play. To check the program During programming: Press RPT/ENT repeatedly before step 5. During the PGM play: Press P MODE repeatedly until "PGM" flashes, then press RPT/ENT. Each time you press RPT/ENT, the track number appears. Notes · When you finish entering the 64th track in step 3, the first selected track appears in the display. · If you select more than 64 tracks, the first selected tracks are erased. 11 B Available features G-PROTECTION function The G-PROTECTION function has been developed to provide excellent protection against sound skipping while jogging. This function provides a higher level of shock protection than the traditional one. While jogging, be sure to hold your CD player with the OPEN switch facing upward. There is no ON/OFF switch of the G-PROTECTION function on this CD player and its remote control. You can always enjoy high quality CD sound using the G-PROTECTION function. Note Sound may skip if: ­ the CD player receives stronger continuous shock than expected or ­ a dirty or scratched CD is played. Checking the remaining time on the CD and the number of tracks left You can check the remaining time on the CD and the number of tracks left using DISPLAY. Press DISPLAY. Each time you press the button, the display changes as follows. Display Normal play Track number and elapsed playing time Press DISPLAY Track number and once. remaining time on the current track Press DISPLAY The number of tracks left* twice. Use only the following dry battery type for your CD player: · LR6 (size AA) alkaline batteries 1 Battery power is getting low. Battery power is low. r Remove the cap of the battery case, and insert two LR6 (size AA) alkaline batteries by matching the 3 to the diagram outside the battery case and close the cap of the battery case. Lo batt* Batteries are depleted. * Beep sounds. To keep the original battery capacity for a long time, charge the batteries only when they are completely depleted. Notes · The indicator sections of roughly show the remaining battery power. One section does not always indicate one-fourth of the battery power. · Depending on operating conditions, the indicator sections of may increase or decrease. 18 2 Connect the battery case to the CD player. Notes on the power source Disconnect all power sources when the CD player is not used. to EXT BATT/ DC IN 4. 5 V On AC power adaptor · Use only the AC power adaptor supplied or recommended in "Accessories (supplied/ optional). " Do not use any other AC power adaptor. It may cause a malfunction. Polarity of the plug With the v side down When to replace the batteries You can check the remaining power of the batteries in the display. Battery power is full. r r r Battery power is getting low. Battery power is low. r · When disconnecting the AC power adaptor from the AC outlet, grasp the adaptor itself. · Do not touch the AC power adaptor with wet hands. On rechargeable batteries and dry batteries · Do not charge the dry batteries. · Do not throw the batteries into fire. · Do not carry the batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the battery are accidentally contacted by a metallic object. [. . . ] c Check that you are using alkaline batteries and not manganese batteries. (page 18) c Replace the batteries with new LR6 (size AA) alkaline batteries. (page 18) c Charge and discharge the rechargeable batteries several times. (pages 17, 18) c The rechargeable batteries are used up completely. [. . . ]