User manual SONY D-F21

[. . . ] To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. CAUTION The use of optical instruments with this product will increase eye hazard. Certain countries may regulate disposal of the battery used to power this product. Please consult with your local authority. [. . . ] The noise will be reduced but the radio will play in monaural. When listening to the radio on batteries If you connect the external power source plug to the DC IN 4. 5 V jack of your CD player, the CD player will turn off. Turn it on by pressing RADIO ON·BAND to continue listening to it. 11 Presetting radio stations You can store radio stations into the CD player's memory. You can preset up to 30 stations, 5 for each band (FM1 - 5 and AM) in any order. 1 2 3 Press RADIO ON·BAND to turn on the radio. Press RADIO ON·BAND to select the band. Hold down MEMORY until "PRESET" flashes in the display. From this step on, start the next operation within 10 seconds after you finished the previous operation. If 10 seconds pass with nothing done, "PRESET" stops flashing which shows that the CD player has exited the PRESET MEMORY standby mode. If this happens, start from step 3 again. Press PRESET + or ­ repeatedly to select the preset number you want to store the station on while "PRESET" flashes. Press TUNE + or ­ to tune in the station you want while "PRESET" flashes. When the station is preset successfully, the beep sounds and "PRESET" stops flashing in the display. · Adjust the volume properly on the CD player and connected device so that the sound will not be distorted or noisy. to i Adjust the volume. Connecting cord Left (white) Right (red) Connecting your CD player Stereo system, cassette recorder, radio cassette recorder, etc. 17 B Connecting to a power source You can use the following power sources: · AC power adaptor (see "Playing a CD") · LR6 (size AA) alkaline batteries For the battery life, see "Specifications. " To remove the batteries Remove the batteries as illustrated below. Using the dry batteries Use only the following dry battery type for your CD player: · LR6 (size AA) alkaline batteries Note Be sure to remove the AC power adaptor when using the dry batteries. When to replace the batteries You can check the remaining power of the batteries in the display. r r r r 1 Open the battery compartment lid. Battery power is getting low. (rear) Battery power is low. Lo batt* Batteries are depleted. 2 Insert two LR6 (size AA) batteries by matching the 3 to the diagram in the battery compartment. * Beep sounds. When the batteries are depleted, replace both batteries with new ones. Notes · The indicator sections of roughly shows the remaining battery power. One section does not always indicate one-fourth of the battery power. If you experience a ringing in your ears, reduce volume or discontinue use. Consideration for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to the people around you. On the CD player · Keep the lens on the CD player clean and do not touch it. If you do so, the lens may be damaged and the CD player will not operate properly. · Do not put any heavy object on top of the CD player. The CD player and the CD may be damaged. · Do not leave the CD player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, unleveled surface, or in a car with its windows closed. [. . . ] (page 18) c Use only the AC power adaptor or car battery cord in "Accessories (supplied/optional). " (back cover) c Remove all power sources, then insert the batteries or connect the AC power adaptor again. (page 15) c The CD is dirty or defective. (page 20) c Check that the CD is inserted with the label side up. (page 6) c Moisture condensation has occurred. [. . . ]