User manual SONY D-FJ211

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. and don't place lighted candles on the apparatus. [. . . ] Do not use different types of batteries together. When the batteries are not to be used for a long time, remove them. If battery leakage occurs, wipe off any deposit in the battery compartment, and install new batteries. In case the deposit adheres to you, wash it off thoroughly. Hold down MEMORY until "PRESET" flashes in the display. From this step on, start the next operation within 30 seconds after you finished the previous operation. If 30 seconds pass with nothing done, "PRESET" stops flashing which shows that the CD player has exited the PRESET MEMORY standby mode. If this happens, start from step 4 again. For the area code of the model you purchased, check the upper left side of the bar code on the package. To add Bookmarks 1 During playback of the track where you want to add a Number you want to store the station on while "PRESET" flashes. Keep the lens on the CD player clean and do not touch it. If you do so, the lens may be damaged and the CD player will not operate properly. Do not put any heavy object on top of the CD player. The CD player and the CD may be damaged. Do not leave the CD player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, unleveled surface, or in a car with its windows closed. If the CD player causes interference to the radio or television reception, turn off the CD player or move it away from the radio or television. , heart, square, star) cannot be played on this CD player. When the station is preset successfully, the beep sounds and "PRESET" stops flashing in the display. To preset another station, press P MODE/ repeat steps 2 to 6. 2 Repeat step 1 to add Bookmarks to the tracks you When the radio is turned on, you can exit the PRESET MEMORY standby mode using one of the following procedures. Preset stations, however, will remain stored in the CD player's memory. Press and hold MEMORY until "PRESET" stops flashing. [. . . ] The volume does not increase even if you press VOL + repeatedly. C Press and hold SOUND until "AVLS" disappears from the display. The interval will not change until you once turn off the radio and then turn it on again. After changing the tuning interval, you need to preset radio stations again. [. . . ]