User manual SONY DC-V515A

[. . . ] 3 Connect the power cord to a wall outlet. The beep sounds and the display window lights up. The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. [. . . ] Full charge requires about 1 hour after normal charge is completed. If you remove the battery pack between normal charge and full charge, the charging time may not be displayed properly in the next charging. When you attach a fully charged battery pack to this unit, "TIME TO CHG FULL 1h" may appear on the display. However, the unit is not malfunctioning. ⷠBATTERY LIFE may not be displayed depending on using conditions and circumstances. ⷠYou may wait for a while after pressing DISPLAY CHANGE until the display shows the time indication. To prevent fire or shock hazard, do not expose the unit to rain or moisture. This unit cannot be used to charge a Ni-Cd/Nickel hydrogen type battery pack. Charge the battery pack on a flat surface without vibration. Align the end of the battery pack having the 4 mark with the edge of the terminal shutter of this unit. A folds down when the battery pack is placed on it. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. The Graphical Symbols with Supplemental Marking is located on the bottom of the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Approximate minutes to charge an empty battery pack fully (Full charge). To ascertain the battery life, refer to the instruction manual of the video equipment which you use. [. . . ] If this unit is not working properly, check to see if the fuse has blown out. If the fuse has blown out, replace it in the following way. Remove the battery pack from this unit, then install the same battery pack again. Design and specifications are subject to change without notice. [. . . ]