User manual SONY DDU100E

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. [. . . ] Should the surrounding temperature suddenly rise while the drive unit is turned on, stop using the drive and leave the power on at least one hour before operating it or turning it off. Operating the drive unit immediately after a sudden increase in temperature may result in a malfunction. s Transportation · Close the disc drawer before moving the drive unit. When you need to ship the drive unit to another location, repacking it in its original container will help you transport it safely. This section explains how to install DDU100E into your PC. You need the following parts and tools (these are not supplied with the drive): · Two mounting rails if your computer has mounting tracks. Unplug the computer and disconnect the cables attached to the back to give yourself more room to work. Do not turn on the power of the computer before completing the entire installation process. Set the jumpers on the rear of the drive unit in accordance with the configuration of your computer system. When the DDU100E is daisy-chained with a Hard Disk Drive on an IDE Card (ATA compliant) set the Hard Disk Drive as MASTER and the DDU100E as SLAVE. It should be noted that some personal computers may use CSEL in lieu of the foresaid MASTER/SLAVE selection. In this case, remove the existing jumpers from MASTER and SLAVE, and set a jumper on CSEL. When the CSEL signal of the interface connector is set low, the drive is designated as Drive 0. when the CSEL is set high , the drive is designated as Drive 1. Consult your PC manufacturer or dealer for further details. 1 If your computer has its rear side covered by a plastic panel Attached with plastic hook pad, pull it off. Cover mounting screw If mounting rails are necessary, attach them to the drive in unit the same way as your floppy disk drive and slide the drive unit into the lower drive bay. If mounting rails are not required in your system, fasten the drive unit in place with mounting screws. Slide the drive unit into the lower bay. Connect the drive unit to the computer with the following connectors: · GND tab (unless the frame of the drive unit is in direct contact with the computer's chassis). [. . . ] The disc tray has four disc locks that prevent the disc from falling when the drive unit is set up in vertical position. When the drive unit is used in horizontal position, you do not need to lock the disc. S Locking and unlocking All of the four locks are set in the unlocked position (facing outward) when the drive is shipped from the factory. To set the lock in the locked position, turn it with your fingers until you hear a click so that it faces inward. [. . . ]