User manual SONY DDU220E

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Playback of DVD-Video discs requires a PC with Windows 95 OSR2, video playback software and appropriate hardware (MPEG2 card etc. For further details, refer to the documentation that comes with DVD-Video playback software. To access data on DVD-ROM or CD-ROM discs, correct device driver must be installed on your PC. Different software may be required depending on the type and format of data on the discs. Therefore, be sure to refer to the documentation that comes with the discs. To use the DVD-ROM drive unit, the following components are required: · Software (Device driver, Utilities) The following is an example of system setup. 3 Volume contr ol Controls the volume level of sound output from the headphones jack 2. 4 DVD indicator This green indicator light or goes off to indicate one of the following unit conditions. Off: CD-ROM disc is loaded 5 Busy indicator This amber indicator lights or flashes to indicate one of the following unit conditions. ⷠSteady lit: TOC (table of contents) read, seek data read, or audio playback in progress. 6 Emergenc y eject hole Used to open the disc drawer manually when neither the eject button 7 nor a software command works. Slide the drive unit into the lower bay. Connect the drive unit to the computer with the following connectors: · GND tab (unless the frame of the drive unit is in direct contact with the computer's chassis). After matching the beveled edges, insert the plug of the power supply cable to the DC INPUT connector and push it firmly in place. Caution: Improper connection may damage the drive unit and void the warranty. S AUDIO OUT connector The pin assignment is as follows: pin 1 2 3 4 Audio Signal R signal R ground L ground L signal 3 Fasten the screws and front brackets as they were before. 4 Tuck the cables behind the drive so that they do not protrude Above the power supply module. 5 After checking the following points, slide the computer's cover On and fasten the cover mounting screws at the back of the computer. ⷠAre the connections between the drive unit and computer correct?6 Remount the rear plastic panel and refer back to the proper Installation section if you answered "no" to either of the questions above. This section describes how to start the drive unit and eject a disc. For double-side DVD disc, signals are read from the side facing down. [. . . ] Caution: Do not forcibly close the disc drawer. The eject button does not work if it is disabled by: ­ the software you are using s Opening the drawer manually in an emergency You can open the drawer manually when it fails to come out by means of the eject button or software commands. To do this, follow the procedure below: 1 Turn off the power of your computer. 2 Insert a pointed object, such as a paper clip, into the emergency After removing a disc from the drive unit, consult your dealer or qualified service personnel. [. . . ]