User manual SONY DE400

[. . . ] This decreases the frequency of sound skipping and the need to utilize the buffer memory. Use this function when listening in a car or while walking. * * Although ESP2 provides excellent protection against skipping, it will not prevent skipping while jogging or running. ESP = once** If you want to play a CD right now, choose to use your player on house current. Other choices are the following three: rechargeable battery, dry batteries (see "Power Sources" on the reverse side) and car battery. = repeatedly** During play, press PLAY MODE repeatedly until "SHUF" appears. [. . . ] Press REPEAT/ENTER while the track you want is playing. To skip the track, press + or just wait for the next track. If you press p, the program will be erased. To prevent accidental erasure, set the RESUME switch to ON. To cancel RMS play, press PLAY MODE until "RMS" disappears. Slide HOLD in the direction of the arrow. When you press any button, "Hold" appears in the display and you cannot operate the player. To unlock, slide HOLD back. For the customers not in Europe The CE mark on the unit is valid only for products marketed in the European Union. Notes on handling CDs · To keep the CD clean, handle it by its edge. · Do not stick paper or tape onto the CD. · Do not expose the CD to direct sunlight or heat sources such as hot air ducts. Do not leave the CD in a car parked under direct sunlight. 1 Press (. After you have gone through the CD, "INTRO PGM" stops flashing and the tracks you have chosen play automatically. To finish programming before going through the whole CD, press ^. If you press p, the program will be erased. m Close the lid of the unit and the battery compartment firmly. m Make sure the batteries are inserted correctly. The CD does not play. m Rechargeable battery or dry batteries are used up. Charge the rechargeable battery or replace dry batteries with new ones. For the customers having purchased the world model Certain countries may regulate disposal of the battery used to power this product. Please consult with your local authority. No sound, or noise is heard. m Connect the plugs firmly. Clean the plugs with a dry soft cloth periodically. OFF RESUME ON 3 On the player Connect the AC power adaptor. The indication "CHG" lights up. Charge for about 2 hours (for BP-DM10) or 3. 5 hours (for BP-DM20). (If the battery has been fully charged, flash. ) "CHG" and · Keep the lens of the player clean and do not touch it. If you do so, the lens may be damaged and the player will not operate properly. [. . . ] Replace them with new ones. To turn off the beep You can turn off the beep that sounds as you operate your player. Disconnect the power source (AC power adaptor, rechargeable battery or alkaline batteries). While you press and hold down p, connect the power source again. To make the beep sound again, disconnect the power source, and then connect it without pressing p. DC IN 4. 5 V On headphones/earphones Road safety Do not use headphones/earphones while driving, cycling, or operating any motorized vehicle. [. . . ]