User manual SONY DEJ2000

[. . . ] 3-245-377-21 (3) Portable CD Player Operating Instructions About the area code The area code of the location in which you purchased the CD player is shown on upper left of the bar code label on the package. For accessories supplied with your CD player, check the area code of your model and see "Accessories (supplied/optional). " "WALKMAN" is a trademark of Sony Corporation. D-EJ2000 © 2002 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. And don't place lighted candles on the apparatus. [. . . ] If the AC power adaptor does not fit the AC outlet, use the AC plug adaptor. CHARGE lamp 1 Open the battery compartment lid inside your CD player. to DC IN 3 V Align V with v. Connecting to a power source 2 Insert a rechargeable battery by matching the 3 to the diagram in the battery compartment and close the lid until it clicks into place. AC power adaptor to an AC outlet (Continued) Insert the # end first. 19 Using the rechargeable battery Charging of the battery starts. In the display of the remote control, "Charging" indication flashes and the indicator sections of light up in succession. The CHARGE lamp lights up on the CD player. When the battery is completely charged, all indications in the display disappear and the CHARGE lamp goes off. To charge the rechargeable battery without using the supplied charging stand Connect the AC power adaptor to the DC IN 3 V jack of your CD player and an AC outlet, then press x/CHARGE to start charging. x/CHARGE button·CHARGE lamp to DC IN 3V AC power adaptor to an AC outlet Notes · When charging the battery using the charging stand, be sure to remove the external battery case. · During charging, the CD player and the rechargeable battery become hot. · If you press the jog lever during charging, charging stops and playback of the CD starts. · If you place the CD player on the charging stand during playback, playback stops and charging starts. · Place the CD player on the charging stand securely, aligning the V mark on the CD player with the v mark on the stand. Make sure that the CHARGE lamp on the CD player lights up. Wrong placement interrupts charging or playback. 20 To remove the rechargeable battery Push # end to remove the battery. When to replace the rechargeable battery If the battery life becomes shorter by about half, replace the battery with new rechargeable battery. Note on the rechargeable battery If the battery is new or has not been used for a long time, it may not be charged completely until you charge and discharge it several times. When to charge the rechargeable battery You can check the remaining power of the battery in the display. Battery power is full. r r r r Note on carrying the rechargeable battery Use the supplied battery carrying case to prevent unexpected heat. If the rechargeable battery and the metallic objects are contacted, heat or fire may occur due to a short circuit. Notes on the supplied charging stand · The supplied charging stand can be used only with this CD player. No other model can be charged using this stand. · When using the supplied charging stand, charge the NH-14WM (A) rechargeable battery only. · During charging, the CD player and the rechargeable battery become hot. · Do not place coins or other metallic objects on the charging stand. If the terminal on the charging stand is accidentally brought into contact with a metallic object, it may short-circuit and begin to heat up. Battery power is getting low. Battery power is low. r Connecting to a power source Lobatt* The battery is depleted. * Beep sounds. To keep the original battery capacity for a long time, charge the battery only when it is completely depleted. Notes · The indicator sections of roughly show the remaining battery power. One section does not always indicate one-fourth of the battery power. · Depending on operating conditions, the indicator sections of may increase or decrease. 21 Using the dry battery Make sure to use the supplied external battery case. Use only the following dry battery type for your CD player: · LR6 (size AA) alkaline battery 3 Connect the external battery case to the CD player. 1 Align the lines below PUSH as illustrated, then draw out the battery case while pressing PUSH. Align to EXT BATT When to replace the battery You can check the remaining power of the battery in the display. [. . . ] c The external battery case is connected to the CD player. c The CD player is not placed securely on the charging stand. Place the player on the stand, aligning the V mark on the player and the v mark on the stand. Make sure that the CHARGE lamp lights up. [. . . ]