User manual SONY DEJ725

[. . . ] 3-225-010-22 (1) Portable CD Player Operating Instructions About the area code The area code of the location in which you purchased the CD player is shown on upper left of the bar code label on the package. For accessories supplied with your CD player, check the area code of your model and see "Accessories (supplied/optional). " D-EJ725 © 2000 Sony Corporation Certain countries may regulate disposal of the battery used to power this product. Please consult with your local authority. 2 Table of Contents Getting started Locating the controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Connecting a power source Using the rechargeable batteries . . . . . . . . . . . . . . . . [. . . ] · Adjust the volume properly on the connected device so that the sound will not be distorted. When using the connecting cord If the sound is distorted, connect the device to the i jack. When using the optical digital connecting cord To record a CD on a MiniDisc, DAT, etc. , make sure that the CD player is in pause before operating the recording procedures. About the G-PROTECTION and SOUND functions when using the connecting cord or optical digital connecting cord · To record high quality CD sound, set the G-PROTECTION switch to "OFF. " · The SOUND function works only on the output sound from the i jack and not work on the output sound from the LINE OUT (OPTICAL) jack. to LINE OUT (OPTICAL) Optical digital connecting cord Connecting cord Left (white) Right (red) MiniDisc recorder, DAT deck, etc. Stereo system, cassette recorder, radio cassette recorder, etc. 14 About Joint Text (CD text copying function) The Joint Text function allows you to copy the disc and track names that are on a CD containing CD text information. By connecting a Sony MD Walkman (MZ-R90/ R91/R900), which supports Joint Text, to this CD player, you can copy the CD text onto an MD during recording. You must use an optical digital connecting cable (POC-15B or other model, not supplied) and the RK-TXT1 CD text connecting cable (not supplied) to make the connections. For details, refer to the operating instructions of the MD Walkman. Using your CD player in a car You can use your CD player in a car by connecting it to the car cassette deck. You cannot use the car mount plate for this CD player. If you press x/CHG after the charge has already been completed, the indicator flashes and "Full" appears in the display. 4 Disconnect the AC power adaptor. 16 To remove the rechargeable batteries Remove the batteries as illustrated below. When to replace the rechargeable batteries If the battery life becomes shorter by about half, replace the batteries with new rechargeable batteries. Note on the rechargeable batteries If the battery is new or has not been used for a long time, it may not be charged completely until you charge and discharge it several times. When to charge the rechargeable batteries You can check the remaining power of the batteries in the display. Battery power is full. r r r r Note on carrying the rechargeable batteries Use the supplied battery carrying case to prevent unexpected heat. If the rechargeable batteries and the metallic objects are contacted, heat or fire may occur due to a short circuit. To attach the battery compartment lid If the battery compartment lid is detached by an accidental drop, excessive force, etc. , attach it as illustrated below. Battery power is getting low. Battery power is low. Connecting a power source r Lo batt* Batteries are depleted. * Beep sounds. To keep the original battery capacity for a long time, charge the batteries only when they are completely depleted. Notes · The indicator sections of roughly shows the remaining battery power. One section does not always indicate one-fourth of the battery power. · Depending on operating conditions, the indicator sections of may increase or decrease. 17 Using the dry batteries Use only the following dry battery type for your CD player: · LR6 (size AA) alkaline batteries Note Be sure to remove the AC power adaptor when using the dry batteries. Using the external battery case You can extend power by inserting the rechargeable batteries or dry batteries in the CD player and attaching the external battery case. The batteries in the CD player and external battery case are discharged simultaneously. Notes · Be sure to remove the AC power adaptor when attaching the external battery case. · When using the rechargeable batteries and dry batteries together to extend power, use fully charged rechargeable batteries and new dry batteries. 1 2 Open the battery compartment lid. Insert two LR6 (size AA) batteries by matching the 3 to the diagram in the battery compartment. To remove the batteries Remove the batteries in the same way as rechargeable batteries. When to replace the batteries You can check the remaining power of the batteries in the display. Battery power is full. r r r r 1 Unlock the cap of the external battery case, and insert two LR6 (size AA) alkaline batteries by matching the 3 to the diagram outside the external battery case and close the cap of the external battery case. Battery power is getting low. Battery power is low. r Lo batt* Batteries are depleted. * Beep sounds. When the batteries are depleted, replace both batteries with new ones. 18 2 Connect the external battery case to the CD player. With the v side down Notes on the power source Disconnect all power sources when the CD player is not used. On AC power adaptor · Use only the AC power adaptor supplied or recommended in "Accessories (supplied/ optional). " Do not use any other AC power adaptor. It may cause a malfunction. Polarity of the plug to EXT BATT/ DC IN 4. 5 V · When disconnecting the AC power adaptor from the AC outlet, grasp the adaptor itself. · Do not touch the AC power adaptor with wet hands. On rechargeable batteries and dry batteries · Do not charge the dry batteries. · Do not throw the batteries into fire. · Do not carry the batteries with coins or other metallic objects. [. . . ] (supplied/optional). " (back cover) c Remove all power sources, then insert the batteries or connect the AC power adaptor again. (pages 6, 16 - 18) The CD does not play or c The buttons are locked. (page 12) "no dISC" appears in the c The CD is dirty or defective. (page 20) display when a CD is placed c Check that the CD is inserted with the label side up. [. . . ]