User manual SONY DFJ405

[. . . ] 3-240-299-71 (1) TV/WB/FM/AM Portable CD Player Operating Instructions About the area code The area code of the location in which you purchased the CD player is shown on upper left of the bar code label on the package. For accessories supplied with your CD player, check the area code of your model and see "Accessories (supplied/optional). " Owner's Record The model number and the serial number are located at the rear of the CD player. Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. [. . . ] 9 kHz area: Asia and Europe 10 kHz area: the U. S. A. , Canada and South America Notes · The interval will not change until you once turn off the radio and then turn it on again. · After changing the tuning interval, you need to preset radio stations again. 16 B Available features G-PROTECTION function The G-PROTECTION function has been developed to provide excellent protection against sound skipping during many active uses. This function provides a higher level of shock protection than the traditional one. Set G-PROTECTION (under the lid) to "ON. " Emphasizing the bass sound (SOUND) You can emphasize the bass-boosted sound. Press SOUND to select "BASS "BASS . " "No indication" (Normal play) " or BASS BASS To turn off the G-PROTECTION function Set G-PROTECTION to "OFF. " Available features Note Sound may skip: ­ if the CD player receives stronger continuous shock than expected, ­ if a dirty or scratched CD is played or ­ when using poor-quality CD-Rs/CD-RWs or if there is a problem with the recording device or application software. The selected sound mode is displayed. "BASS " enhances the bass sound more than "BASS . " Note If the sound is distorted when using the SOUND function, turn down the volume. 17 Protecting your hearing (AVLS) The AVLS (Automatic Volume Limiter System) function keeps down the maximum volume to protect your hearing. Hold down SOUND until "AVLS" appears in the display. Locking the controls (HOLD) You can lock the controls on your CD player to prevent accidental button presses. Slide HOLD in the direction of the arrow. Displayed when AVLS function is activated. To turn off the AVLS function Hold down SOUND until "AVLS" disappears from the display. Displayed when the HOLD function is activated. You can use the HOLD function with both the CD player and remote control. You can still operate your CD player using the remote control when HOLD on the remote control is set to off. To unlock the controls Slide HOLD in the opposite direction of the arrow. 18 Turning off the operation beep sound You can turn off the beep sound that is heard from your headphones/earphones when you operate your CD player. 1 2 Remove the power source (AC power adaptor, rechargeable batteries or dry batteries) from the CD player. Connect the power source while pressing x/CHG on the CD player or x on the remote control for about one second or more. To turn on the beep sound Remove the power source and then connect the power source without pressing x/CHG or x. Available features 19 B Connecting your CD player Connecting a stereo system You can listen to CDs through a stereo system and record CDs on a cassette tape. For details, see the instruction manual that comes with the connected device. Be sure to turn off all connected devices before making connections. Notes · Before you play a CD, turn down the volume of the connected device to avoid damaging the connected speakers. · Use the AC power adaptor for recording. If you use the rechargeable batteries or dry batteries as a power source, batteries may become completely depleted during recording. · Adjust the volume properly on the connected device so that the sound will not be distorted. When using the connecting cord · If the sound is distorted, connect the device to the i jack. · The SOUND function does not work. · The output level of the i jack goes down. About the G-PROTECTION and SOUND functions when using the connecting cord · To record high quality CD sound, set the G-PROTECTION switch to "OFF. " · The SOUND function works only on the output sound from the i jack and not work on the output sound from the LINE OUT jack. to LINE OUT Connecting cord Left (white) Right (red) Stereo system, cassette recorder, radio cassette recorder, etc. 20 B Connecting to a power source You can use the following power sources: · Rechargeable batteries · AC power adaptor (see "Playing a CD") · LR6 (size AA) alkaline batteries For the battery life and charging time of the rechargeable batteries, see "Specifications. " 3 Connect the AC power adaptor to the DC IN 4. 5 V jack of your CD player and an AC outlet, then press x/CHG to start charging. x /CHG button Using the rechargeable batteries Charge the rechargeable batteries before using them for the first time. You can use only the following rechargeable batteries for your CD player. · NC-WMAA · NH-WM2AA (NH-WMAA × 2) to DC IN 4. 5 V 1 Open the battery compartment lid inside your CD player. AC power adaptor to an AC outlet 2 Insert two rechargeable batteries by matching the 3 to the diagram in the battery compartment and close the lid until it clicks into place. The CD player charges the batteries. The indicator sections of light up in succession. [. . . ] Playback starts from the point you stopped. (resume function) Rustling noise of the CD is heard. When closing the lid of the CD player, the CD starts to rotate. You cannot operate the CD player properly using the remote control. [. . . ]