User manual SONY DHC-FL7D

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. US and foreign patents licensed from Dolby Laboratories Licensing Corporation. This caution label is located inside the unit. 9 Making a space between tracks 3 seconds long . [. . . ] Making a space between tracks 3 seconds long â­Â­ Smart space , Auto Cut The Smart Space and Auto Cut functions let you make a blank space between tracks three seconds long automatically while making a digital recording. If there is extended silence of 4 to 29 seconds while digital recording, the MD deck replaces the silence with a blank of about 3 seconds and continues recording. If there is no sound input for 30 seconds while digital recording, the MD deck replaces the silence of 30 seconds with a blank of about 3 seconds and changes to recording pause. If you turn the power off or disconnect the mains lead, the MD deck will recall the last setting (on or off) of the Smart Space and Auto Cut functions the next time you turn the power on. â· The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following: ­ Remove the MD. Press r REC while recording at the point you want to add a track mark. The tracks following the added one are renumbered. By using the editing functions, you can create a new sequence to the recorded MD. Before editing, check the conditions by following the procedure below. If you enter an incorrect character, pressCURSOR ?Or / until the character you want to change flashes, then repeat steps 4 through 6. To erase a character, press CANCEL/NO while the character is flashing. You cannot insert characters between previously inserted characters. To lavel a track, press MD + or = until the desired track number appears. The titles you labelled appears sequentially, then the display returns to the original. Press EDIT then press +/­ repeatedly until "Name in ?You can label a track title while playing, but you must complete labelling before the track ends. â· If the MD is record protected, "MD Protected" appears in the display and the MD cannot be recorded on. Press MD § and remove the MD, slide the record protection tab to the closed position (see page 28), insert the MD and try again. The MD deck lets you erase unwanted tracks quickly and easily. [. . . ] A strong signal was input during recording in the TAPE function. When the sound is distorted, reduce the recording level, then re-record. If distortion may occurs: 1 Stop play or turn off the power of the other component connected to the TAPE input. 6 Turn on the power of the other component connected to the TAPE input and continue recording or start recording over from the beginning. [. . . ]