User manual SONY DHC-MD313

[. . . ] The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] You can use upper case, numbers and symbols for the titles. ⷠErase ­ Erasing recordings Use this Function to erase a single track one by one or all tracks at once. ⷠMove ­ Changing the order of tracks Use this Function to change the track numbering. ⷠDivide ­ Marking track numbers on recorded radio programmes Use this function to add track numbers. This lets you locate your favorite phrases quickly. ⷠCombine ­ Combining recorded tracks By using this function, the blank space between two tracks is erased and those two tracks are combined to one track. You can combine the tracks which are not numerically consecutive, i. ⷠUndo ­ Cancelling the last edit Use this function to cancel the last edit and restore the contents of the MD to the condition before the edit. If the MD is record protected, "MD Protected" appears in the display and the MD cannot be edited. If the MD is protected against erasure, slide the tab to close the slot. You can edit the MD only in continuous mode. The MD editing is complete only after all the editing information is entered to TOC at which point TOC stops flashing and goes out. Be careful disconnect the mains lead or move the deck before this point. Before disconnecting the mains lead, do the following: ­ Remove the MD. If you a labeled CD on a new MD, the title is automatically recorded on the MD (Disc Memo Copy function). You can also create titles (names) for your recorded MDs and tracks. You can use up to 1, 700 characters for a disc. Press CHARACTER repeatedly until the type of character you want appears. Each time you press the button, the display changes as follows: A (Upper case) n a (Lower case) n 0 (Numbers) n !Press +/­ repeatedly until the character you want appears. The character you selected in step 5 stops flashing and the cursor shifts to the right. Repeat steps 4 through 6 to complete the entire title. [. . . ] Remove the MD and leave the system turned on for several hours until the moisture evaporates. Level Over A strong signal was input during analog recording in the TAPE function. Name Full There is no more space to store track or disc titles. NEW The MD deck stands by for recording on a brand new MD or from the last recorded portion. [. . . ]