User manual SONY DHC-MD373

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The following caution label is located inside of the unit. 27 Starting recording with 6 seconds of prestored audio data -- Time Machine Recording . 30 Making a space between tracks 3 seconds long -- Smart Space . [. . . ] "TOC" lights up or starts flashing. Before pulling out the mains lead Do not pull out the mains lead before updating the TOC (while "TOC" is lit) or while updating the TOC (while "TOC" is flashing) to ensure a complete editing. You can create titles for your recorded MDs and tracks as follows. To enter a blank space You cannot enter a space as the first character. If "CD TEXT" flashes in the display during recording a CD, you can record the CD disc title on the MD (see page 27). You can input a total of approximately 1700 characters for the disc title and track titles on a single MD. The character you selected in step 4 stops flashing and the cursor shifts to the right. Repeat steps 3 to 5 to complete the entire title. If you make a mistake Press CURSORT or t until the character you want to change flashes, then repeat steps 3 to 5. Press CLEAR while the character is flashing. Or > until the desired track number appears. The titles you labelled appear sequentially, and then the original display appears. Each time you press the button, the display changes as follows: (Blank space) t A (Upper cases) t a (Lower cases) t 0 (Number) t !You can label a track title during play. If the MD is record protected, "C11" and "Protected" appear alternately and the MD cannot be recorded. Remove the MD, then slide the record protection tab to the closed position (see page 25). You can copy a labeled disc or track title to use it as a title of another track or the disc title within a disc. Or > repeatedly to select "Disc" (when copying the disc title) or the track number with the title you want to copy, then press ENTER/YES. Or > repeatedly to select the copy destination track number or "Disc" (when copying as the disc title), then press ENTER/ YES. The MD deck lets you erase unwanted tracks quickly and easily. You can restore the contents to the condition before erasing (unerase) by using the Undo function. Note, however, you cannot undo an edit after performing any additional edits. [. . . ] CRemove the MD once, then insert it again. If the system still does not operate properly after performing the above measures, reset the system as follows: All the settings you made such as the preset stations, clock, timer and CD disc titles are cleared and must be set again. C41/CannotCopy The sound source is a copy of a commercially available music software, or you tried to record a CD-R (Recordable CD). CThe Serial Copy Management System prevents making a digital copy (see page 55). [. . . ]