User manual SONY DHC-MD500

[. . . ] The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] When you want to reduce the hiss noise in lowlevel high-frequency signals, press DOLBY NR so that "DOLBY NR" appears after pressing r REC. When recording from a CD, you can use the jog dial to select tracks during rec pause mode (after pressing r REC in step 3 and before pressing P PAUSE in step 5). Press FUNCTION repeatedly until the source you want to record (e. The indicator on TAPE B ( (for front side) lights up. You can record tracks from all the CDs in the order you want. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Turn the jog dial until the desired track appears in the display. The program step number appears, followed by the total playing time. Skip step 4 to select tracks from the same disc. Repeat steps 5 and 6 for tracks from the same disc or steps 4 to 6 for tracks from another disc to program the remaining tracks to be recorded on side B. Note that you cannot use Tape Select Edit for discs containing over 20 tracks. The indicator on TAPE B ( (for front side) lights up. The required tape length for the currently selected CD appears, followed by the total playing time for side A and side B respectively. Select ß (or RELAY) to record on both sides. You cannot use this function after programming. In order to use this function, you must first cancel the program by pressing PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. After the last track, "CHECK END" appears. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. tip When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR" appears after pressing CD SYNC. With the loop function, you can repeat part of a CD during playback. This lets you create original recordings. With the flash function, you can "flash" the CD sound during playback. [. . . ] Move the stereo system away from the TV or VCR. DAILY1, DAILY 2, and REC do not appear when you press the TIMER SELECT button. There is an obstacle between the remote and the system. Move the microphone away form the speakers or change the direction of the microphone. [. . . ]