User manual SONY DHC-NX5MD

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. The following caution label is located inside the unit. The use of optical instruments with this product will increase eye hazard. [. . . ] You can copy a labelled disc or track title to use it as a title of another track or the disc title within a disc. 4 Turn MD JOG to select "Disc" (when copying the disc title) or the track number with the title you want to copy, then press ENTER/YES. 5 Turn MD JOG to select the copy destination track number or "Disc" (when copying as the disc title), then press ENTER/YES. " appears The copy destination already has a disc or track title. The character you selected in step 4 stops flashing and the cursor shifts to the right. Repeat steps 3 to 5 to complete the entire title. If you make a mistake Press MD m or M until the character you want to change flashes, then repeat steps 3 to 5. Press CLEAR while the character is flashing. To check the track title, press SCROLL during play. The MD deck lets you erase unwanted tracks quickly and easily. You can restore the contents to the condition before erasing (unerase) by using the Undo function. Note, however, you cannot undo an edit after performing any additional edits. 4 Turn MD JOG until the desired title to erase appears, then press ENTER/YES. You can erase a track simply by selecting its track number. When you erase a track, the total number of tracks on the MD decreases by one and all the tracks following the erased one are renumbered. Track number Original tracks Erase track 2 To return to the condition before labelling or erasing You can return to the original condition immediately after labelling or erasing a title (see page 51). When erasing multiple tracks, you should proceed in order from high to low track number to prevent the renumbering of tracks that have not been erased yet. " appears for a few seconds and the selected track and title are erased. To return to the condition before erasing You can return to the original condition immediately after erasing the tracks (see page 51). " appears when the track was recorded or edited on another deck and is protected. To erase the track, press ENTER/YES while "Erase?You can erase the disc title, all recorded tracks and their titles at once. [. . . ] You tried to make an impossible editing operation. F Edit (changing the recording level after recording, Fade-in, Fade-out) operation was not performed properly because the system was moved while recording was in progress or the MD is damaged or dirty . Initialize The power was off for a long time, so the system is initializing itself. There is no more space to store track or disc titles. [. . . ]