User manual SONY DMJ95

[. . . ] 3-047-253-21 (1) Portable CD Player Operating Instructions About the area code The area code of the location in which you purchased the CD player is shown on upper left of the bar code label on the package. For accessories supplied with your CD player, check the area code of your model and see "Accessories (supplied/optional). " D-MJ95 2000 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. CAUTION The use of optical instruments with this product will increase eye hazard. [. . . ] To route the cord Use the supplied spiral tube to route the cords so that they do not interfere with your driving. Note on the car battery cord The 4. 5V DC plug supplied with car battery cord conforms to the proposed standards of the Electronic Industries Association of Japan (EIAJ). Do not connect it to other players. Mounting your CD player Attach the CD player to the console box with the supplied Velcro tapes. Bottom of the CD player Polarity of the plug (EIAJ standards) Console box 16 Replacing the fuse of the car battery cord If the player does not operate, check the fuse. If it is blown, replace it as follows: Notes on the car connecting pack · If no sound is heard or the car connecting pack is ejected, change the direction of playback on the car cassette deck. · Never insert the cord end of the car connecting pack into the cassette insertion door. Otherwise, the cord may break or the car cassette deck may be damaged. · You cannot use the car connecting pack with some car cassette deck. · The cord should be placed so that it does not hinder driving. · To disconnect the cord from the player, pull it out by grasping the plug. · With some car cassette decks, you may hear some rattling noise from the car connecting pack. However, this is not a sign of malfunction. 1 2 3 4 5 Turn off the CD player and remove the cigarette lighter plug from the cigarette lighter socket. Remove the plug end by turning it counterclockwise. Remove the defective fuse from the plug. Replace the plug end by turning it clockwise. Remove Fuse Installing in a car Plug end Cigarette lighter plug Notes · Be sure to use a fuse of the same amperage and length as the one to be replaced. Never use a piece of wire as a substitute for the fuse. · If the fuse is blown again after replacing it, contact your nearest Sony dealer. In such a case, bring the defective fuse to the dealer with you. 17 Mounting the rotary commander If you use the supplied rotary commander, you can control your CD player as you would control the headlight or the wiper switch of your car while driving. Attach the rotary commander to a flat place as illustrated below. 1 Attach the mounting hardware to the rotary commander by aligning the four catches on the mounting hardware to the four holes on the bottom of the commander and sliding the hardware until it locks into place. 2 Attach the rotary commander to a flat place with the double-sided adhesive tape. Bottom of the mounting hardware Console box 18 To mount the rotary commander more securely using the supplied screw 1 Attach the mounting hardware to the mounting place (console box, etc. ) with the double-sided adhesive tape. 2 Screw the mounting hardware on the mounting place. Screw hole 3 Attach the rotary commander to the mounting hardware. Note If you use the supplied screw, you have to drill a hole on the mounting place of your car; however, this allows you to mount the commander more securely. To route the cord Use the supplied cramper to route the cords so that they do not interfere with your driving. Installing in a car 19 B Connecting a power source You can use the following power sources: · AC power adaptor · Rechargeable batteries · LR6 (size AA) alkaline batteries For the battery life and charging time of the rechargeable batteries, see "Specifications. " Using the rechargeable batteries Charge the rechargeable batteries before using them for the first time. You can use only the following rechargeable batteries for your CD player. · NC-WMAA · NH-WM2AA Using the AC power adaptor Connect the supplied AC power adaptor to the DC IN 4. 5 V jack and an AC outlet. to an AC outlet 1 Open the battery compartment lid. (rear) 2 to DC IN 4. 5 V Insert two rechargeable batteries by matching the 3 to the diagram in the battery compartment and close the lid. 20 3 Connect the AC power adaptor to the DC IN 4. 5 V jack of your CD player and an AC outlet, then press x/CHG to start charging. x/CHG button To remove the rechargeable batteries Remove the batteries as illustrated below. to DC IN 4. 5 V When to charge the rechargeable batteries You can check the remaining power of the batteries in the display. Battery power is full. r Battery power is getting low. r r To an AC inlet r Battery power is low. Lo batt* Batteries are depleted. The CD player charges the batteries. [. . . ] (page 22) c Replace the batteries with new LR6 (size AA) alkaline batteries. (page 22) c Charge and discharge the rechargeable batteries several times. (pages 20 - 22) c The rechargeable batteries are used up completely. (pages 20 - 22) c Replace the batteries with new LR6 (size AA) alkaline batteries. [. . . ]