User manual SONY DNS921F

[. . . ] 3-253-169-41 (1) TV/WB/FM/AM Portable CD Player Operating Instructions "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. is a trademark of Sony Corporation. D-NS921F © 2003 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the AC power adaptor to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. And don't place lighted candles on the apparatus. [. . . ] Press TV, WB, FM or AM for 2 seconds or more. Preset number 1 will flash in the display. 3 4 Press DISPLAY (MEMORY) for 2 seconds or more. The CD player starts scanning the stations from the lower frequencies and stops for about 3 seconds when a station is received. If you want to preset the received station, press DISPLAY (MEMORY) while the preset number is flashing. The received station is preset on the preset number 1 and the CD player starts scanning for the next receivable station. If you do not press DISPLAY (MEMORY) within the 3 seconds, the CD player will start scanning for the next receivable station without storing the station. Repeat step 4 until all receivable stations are preset. If the stations have already been stored, the newly preset stations will replace the old ones. Using the radio 5 To stop scanning · Press TV, WB, FM or AM for 2 seconds or more. · Push the 4-way control key toward x·CHG (RADIO OFF). The radio is turned off at the same time. To play preset stations 1 Press TV, WB, FM or AM. or > to tune in a stored station. (Continued) 27 To preset stations manually If the stations cannot be preset automatically, preset the stations manually. 1 Press TV, WB, FM or AM to select the band (direct power-on). 2 Press TV, WB, FM or AM for 2 seconds or more to enter the preset mode. The preset number 1 will flash in the display. 3 While the preset number 1 is flashing, tune in a station you want by pressing TUNING + or ­, and select a preset number by pushing the 4-way control key toward . 4 To store, press DISPLAY (MEMORY) while the preset number is flashing. If there was a station stored on this preset number, the newly preset station will replace the old one and the preset number increases by one. 5 To continue storing, repeat steps 3 and 4. Note If you cannot complete step 3 or 4 while the preset number is flashing in the display, repeat from step 2. To stop storing · Press TV, WB, FM or AM for 2 seconds or more. · Push the 4-way control key toward x·CHG (RADIO OFF). The radio is turned off at the same time. To play preset stations 1 Press TV, WB, FM or AM. or > to tune in a stored station. Changing the tuning interval When using the CD player abroad, change the AM tuning interval, if necessary. Set the STEP switch (inside the lid) to "9 kHz" or "10 kHz" using a pointed material. [. . . ] (resume push the 4-way control key toward u during stop until the first function) track starts playing, or open the lid of the CD player. Or remove all power sources, then insert the batteries or connect the AC power adaptor again. (pages 12, 13, 33) Rustling noise is heard from c Close the lid of the battery compartment firmly. When using with a connected c Adjust the volume of the CD player and the connected device. [. . . ]