User manual SONY DR-BT50

[. . . ] To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To reduce the risk of electrical shock, do not open the cabinet. refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] note When connecting to a Bluetooth mobile phone which is different from the last connected one, make the connection following the above procedure. POWER button for about 3 seconds while the unit is turned off. The indicator (blue) and indicator (red) flash together twice, the unit turns on and then this unit tries to connect to the last Bluetooth mobile phone that was used. note Do not press and hold the POWER button for more than 7 seconds, otherwise pairing mode is entered. This unit will stop trying to connect to the Bluetooth mobile phone after 1 minute. B To make a connection with the last connected Bluetooth device by operating this unit The indicator (blue) and indicator (red) start flashing at the same time, and the unit performs the connection operation for about 5 seconds. note When listening to music with this unit, a Bluetooth connection cannot be made with the multi function button. ­ ring tone set on the unit ­ ring tone set on the mobile phone ­ ring tone set on the mobile phone only for Bluetooth connection note If you received a call by pressing the button on the Bluetooth mobile phone, some Bluetooth mobile phones may have handset use priority. In this case, set to talk with the unit by pressing and holding the multi function button for about 2 seconds, or by operating the Bluetooth mobile phone. You cannot adjust the volume when not communicating. ⷠVolume level for calling and listening to music can be set independently. If no dial tone is heard on this unit, press and hold the multi function button for about 2 seconds. You can end a call by pressing the multi function button on the unit. You can call in the following way, depending on the Bluetooth mobile phone. Refer to the manual supplied with your mobile phone on operating details. ­ When not communicating, you can call using the voice-dial function by pressing the multi function button. ­ You can call the last dialed number by pressing the multi function button for about 2 seconds. POWER button for about 3 seconds to turn off the power. The indicator (blue) and indicator (red) light up together, and the unit turns off. When an incoming call arrives, a ring tone will be heard from the unit. The ring tone differs in the following ways, depending on your mobile phone. The operation of the buttons on this unit varies depending on your mobile phone. [. . . ] , Check that the volume of the unit is not set too low. *2 Note that this may not always reduce the sound skip depending on the circumstances. Press and hold Nx again for about 7 seconds to set the unit so as to receive high bit rate music. , Check that both this unit and the Bluetooth mobile phone are turned on. [. . . ]