User manual SONY DR-NXM01HK2 INSTALLATION & CONNECTIONS

[. . . ] 3-245-381-11(1) Digital Audio Receiver Accessory Kit Installation Guide For customers in the USA Please register this product on line at http://www. sony. com/ productregistration. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you. Parts for Installation and Connection for DRN-XM01C2 Remote commander (1) Car cradle (1) Car stand (1) Screw (5) For DRN-XM01C2/XM01CK2/XM01R2 8 Adjust the angle. Affixing the ferrite core to the AC power Wind the cord around the adaptor (AC-E60A) RFC-8 ferrite core twice, then fasten the catch. Installing the Antenna on the Roof (recommended) Figure of the top Water proof cushion Leading the antenna cord into the car through the space between the door and body When installing the antenna on the roof, you can also lead the antenna cord into the car through the space between door and body. Installing the Cradle in your Car Install the cradle with the supplied car stand. [. . . ] Depending on where you live, you may be able to receive radio waves that are retransmitted by ground repeaters. ** · · · · ***· · Home stand (1) Audio cord (1) AC power adaptor (1) 7 Attach the cradle to the stand. Affixing the ferrite core to the XM antenna Wind the cord around the RFC8 ferrite core once, then fasten the catch. To the stand receptacle at the bottom of the cradle Be sure to install the antenna firmly on a flat surface. Do not install on the corner of the roof. Be sure to install the cord clamp in a lower position where the water proof cushion is mounted. Otherwise, it will cause a water leak into the trunk. Clean the mounting surface before installing the cord clamp. Leave the installed cord clamp for 24 hours before installing the cord. Otherwise, the cord clamp may come off due to weak attachment. To install the cord, insert it into the cord clamp, then press the top of the cord clamp downward so that the cord is securely installed inside the cord clamp. It is difficult to attach the cable guide to a body or window which has fluorine resin coating. Trunk lid Rubber packing Approx. 135 mm (5 3/8 inches) * · Cut the cable guide, if required. Notes · Route the cords so that they will not interfere with your driving. · Take care not to accidentally insert a portion of the car connecting pack cord into the cassette insertion slot. This may cause the cord to break or damage the car cassette deck. · To disconnect the cord from your audio equipment, pull it out by grasping the plug. · If the inside of the cigarette lighter socket is dirty with cigarette ash, the cigarette lighter plug may be heated due to abnormal contact. Be sure to clean the inside of the cigarette lighter socket before inserting the plug. · After using the receiver, eject the car connecting pack from the car cassette deck and disconnect the car battery cord from the receiver and the cigarette lighter socket. · Do not use the receiver when the car's engine is not running. to the DC IN 6V jack POWER ANT For DRN-XM01C2/XM01CK2 Customers Be sure to check that the voltage of the equipment connected to this unit is correct. Incorrect voltage may cause the equipment to malfunction. · This unit is designed for negative ground 12 or 24 V DC operation only. [. . . ] · To avoid short-circuiting, do not allow the terminals of the unit or connector to touch any metal object. · Use only the recommended AC power adaptor. Setting the POWER SELECT Switch This RF modulator supplies power to the receiver and detects the on/off state by monitoring the load of the power. When the receiver is turned on, the RF modulator automatically cuts off the antenna line and directly outputs the sound of the receiver to the car audio with the selected FM frequency. This prevents the sound from disturbing the FM broadcast signal. [. . . ]