User manual SONY DRX-710UL

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Connect the other end of the USB cable to your computer. When the computer is ready, confirm that the drive is detected. The disconnection procedure varies according to your operating system. windows 2000 When your computer successfully detects the drive , appears on the Windows taskbar. When you want to disconnect the drive, you must first stop it using this icon. The " `USB CD-ROM E:' device can now be safely removed from the system" message appears. Now you are ready to disconnect the drive. Windows XP With Windows XP, first confirm that there are no programs running and that the drive's busy indicator is not lit, and then disconnect the USB cable. setup Note If you disconnect the USB cable without performing the procedure outlined above with Windows 2000, the operation of your computer may become erratic or data damaged. Be sure to perform the procedure above before disconnecting the USB cable. 0, which provides a much higher rate of data transfer than the earlier USB 1. The following discs are compatible with the drive. Depending on your software and media, this speed may vary. Only round discs should be used with this drive. Attempting to read odd-shaped discs (stars, hearts, card shape, etc. Operation is not guaranteed when writing to or playing back 99 minute discs. With 8 cm discs, you must place the drive horizontally. We recommend that you only use discs for which operation has been guaranteed. You can obtain the latest list of writable discs for which operation with this drive has been guaranteed at the user support Web site address (see page 34 for details). User support Web site Insert the supplied software disc into the drive, and in the [Menu Selection] screen, click [User Support Web Page]. You can also directly type the user support Web site address (see page 34 for details) in the address box of your Web browser. Note You can safely use most disc formats that comply to the appropriate standards with this drive. [. . . ] Data may not record properly if a scratch or dust is present on the unrecorded area of writable discs. As much as possible, avoid sudden temperature changes. Do not attempt to use the drive immediately after moving it from a cold to a warm location, or raising the room temperature suddenly, as condensation may form within the drive. If the temperature changes suddenly while using the drive, stop using it but keep the power on for at least an hour. [. . . ]