User manual SONY CYBER-SHOT DSC-S750

[. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. For your protection, please read these safety instructions completely before operating the appliance, and keep this manual for future reference. To reduce fire or shock hazard, do not expose the unit to rain or moisture. This set should be operated only from the type of power source indicated on the marking label. [. . . ] Television programs, films, videotapes, and other materials may be copyrighted. Sony cannot compensate for failure to record or loss or damage of recorded content due to a malfunction of the camera or recording media, etc. Attach the strap and place your hand through the loop to prevent the camera from damage by being dropped. When the CHARGE lamp turns off, charging is finished (Normal charge). If you continue charging the battery pack for about one more hour (until it is fully charged), the charge will last slightly longer. The table above shows the time required to charge a fully depleted battery pack at a temperature of 25 °C (77 °F). Charging may take longer depending on conditions of use and circumstances. ⷠSee page 30 for the number of images that can be recorded. Even if the CHARGE lamp is not lit, the battery charger is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet (wall socket). If some trouble occurs while using the battery charger, immediately shut off the power by disconnecting the plug from the wall outlet (wall socket). ⷠWhen charging is finished, disconnect the power cord (mains lead) from the wall outlet (wall socket), and remove the battery pack from the battery charger. You cannot use the Digital Zoom function. ⷠYou cannot change the zoom ratio when the Smile Shutter is in standby. If you press when the camera is powered off, the camera is turned on automatically and set to playback mode. Sometimes images shot using earlier Sony models cannot be played back. Press the HOME button, select [ Folder View] from (View Images), then play back the images. 1 Display the image you want to delete, then press MENU. 2 Select [Delete] with v/V and select [This Image] with b/B, then press z. To return to the single image screen, press z. ⷠIn the default setting, images are displayed in Date View (when using the "Memory Stick Duo") or in Folder View (when using the internal memory). Each time you press (Index), the number of images on the index screen increases. 2 Select [Delete] with v/V and select [Multiple Images] with b/B, then press z. [. . . ] ⷠUnder direct sunlight or near a heater The camera body may become discolored or deformed, and this may cause a malfunction. In sandy or dusty places Be careful not to let sand or dust get into the camera. This may cause the camera to malfunction, and in some cases this malfunction cannot be repaired. If the camera is brought directly from a cold to a warm location, moisture may condense inside or outside the camera. [. . . ]