User manual SONY CYBER-SHOT DSC-U60 NOTICE

[. . . ] · Note that water remaining in the gaps on the camera body may get your clothes or the inside of your bag wet. · In cold places, water droplets may freeze on the camera body. [. . . ] This can scratch the O-ring or the O-ring mating surface which may allow water to leak inside the camera. · Do not place excessive tension on the O-ring. Cleaning the O-ring and the O-ring groove · Use tap water at 30°C or less to wash the O-ring that you removed. · The O-ring is specially treated, so take care not to allow grease or oil to adhere to the O-ring. · When sand particles or encrusted salt may be present in the Oring groove, clean the groove carefully using a cotton swab. Take care that fibers from the cotton swab do not remain in the groove. · Do not use a pointed, sharp or metal object for cleaning, as this may scratch the O-ring groove. On storage Avoid storage in hot, cold or humid places, or places exposed to naphthalene, camphor or other chemicals, as this may damage the camera. 1 You can use this camera in the following places: Underwater (ocean, swimming pools) up to depths of 1. 5 m (5 feet), beachside, riverside, poolside, ski slopes, in the rain, etc. Do not use this camera in the following places: Places where the camera might be subject to high water pressure, hot springs or bathtubs, etc. Leave the camera immersed in a bucket or other container filled with fresh water. · Wash the camera by gently moving it back and forth to thoroughly remove any dirt, sand and salt. Then, let it soak for approximately 30 minutes. · Do not rub the lens or the LCD screen when they are dirty as this may cause scratches. Dirt Sand Hair Dust 2 Wipe the camera. · Wipe away the water on the camera using a clean, dry, soft cloth, then leave the camera in the shade to dry. · Water that is not completely wiped away may seep out later, so place the camera on a soft cloth. Salt Lint Notes on use · Before using this camera underwater or in places exposed to water, be sure to inspect the O-ring and the O-ring mating surface on the inside of the camera. · Do not immerse the camera in water containing soap, detergent, bath salts, etc. , or in hot water with a temperature of more than 30°C. [. . . ] Even if the O-ring has no problems, deformation and wear over time can cause the waterproof performance to drop, so replace the O-ring with a new one after approximately two years of use. · Consult your Sony dealer or local authorized Sony service facility for replacement of O-rings. [. . . ]