User manual SONY CYBER-SHOT DSC-W710/P

[. . . ] Charge lamp Lit: Charging Off: Charging finished Flashing: Charging error or charging paused temporarily because the camera is not within the proper temperature range 1 Press the ON/OFF (Power) button. 3 Select a desired geographic location by following the on-screen instructions, then press z on the control button. 5 mm While shooting movies (4:3): 28 mm – 140 mm SteadyShot: Electronic Burst shooting (when shooting with the largest pixel number): Approx. 28 MB), “Memory Stick Duo” media, “Memory Stick Micro” media, SD cards, microSD memory cards Flash: Flash range (ISO sensitivity (Recommended Exposure Index) set to Auto): Approx. [. . . ] ______________________________ To a USB jack 1 Press the shutter button halfway down to focus. 2 Press the shutter button fully down to shoot an image. 7 oz) Hard Disk (Disk space required Approximately 500 MB for installation) Display *1 *2 1, 024×768 dots or more x Battery life and number of images that can be recorded and played back Battery life Shooting (still images) Actual shooting (movies) Continuous shooting (movies) Viewing (still images) Approx. 8 [ CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. 1 Press the shutter button fully down to start recording. 2 Press the shutter button fully down again to stop recording. Viewing images W: zoom out T: zoom in Control button (Playback) Mac OS (pre-installed) Rechargeable battery pack NP-BN Used battery: Lithium-ion battery Maximum voltage: DC 4. 2 Wh (600 mAh) Design and specifications are subject to change without notice. Notes on using the camera On use and care Avoid rough handling, disassembling, modifying, physical shock, or impact such as hammering, dropping, or stepping on the product. [ Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. € Increase the separation between the equipment and receiver. € Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. € Consult the dealer or an experienced radio/TV technician for help. The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. € The number is based on the CIPA standard. (CIPA: Camera & Imaging Products Association) Notes on recording/playback • Before you start recording, make a trial recording to make sure that the camera is working correctly. [. . . ] Press z in the center of the control button to view movies. No compensation for damaged content or recording failure Sony cannot compensate for failure to record or loss or damage of recorded content due to a malfunction of the camera or recording media, etc. Additional information on this product and answers to frequently asked questions can be found at our Customer Support Website. x Deleting an image 1 Press (Delete) on the control button. [. . . ]