User manual SONY CYBER-SHOT DSC-WX9

[. . . ] The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to these numbers whenever you call your Sony dealer regarding this product. To reduce fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] The above charging time applies when charging a fully depleted battery pack at a temperature of 25°C (77°F). Charging may take longer depending on conditions of use and circumstances. X Battery life and number of images you can record and view battery life Shooting (still images) Viewing (still images) Shooting (movies) Notes · The above number of images applies when the battery pack is fully charged. The number of images may decrease depending on the conditions of use. The number of images that can be recorded is for shooting under the following conditions: ­ Using Sony "Memory Stick PRO Duo" (Mark2) media (sold separately) ­ The battery pack is used at an ambient temperature of 25°C (77°F). The number for "Shooting (still images)" is based on the CIPA standard, and is for shooting under the following conditions: (CIPA: Camera & Imaging Products Association) ­ DISP (Display Setting) is set to [ON]. ­ The flash strobes once every two times. ­ The power turns on and off once every ten times. The battery life for movies applies shooting under the following conditions: ­ Movie quality: AVCHD HQ ­ When continuous shooting ends because of set limits (page 22), press the MOVIE (Movie) button again and continue shooting. Shooting functions such as the zoom do not operate. The camera can be supplied with power from the wall outlet (wall socket) by connecting to the AC Adaptor, using the multi-use terminal USB cable (supplied). You can import images to a computer without worrying about wearing down the battery pack by connecting the camera to a computer using the multi-use terminal USB cable. notes · Power cannot be supplied when the battery pack is not inserted in the camera. Power supply from the wall outlet (wall socket) is available only when the camera is in playback mode or when a connection is made between the camera and a computer. If the camera is in shooting mode or while you are changing the settings of the camera, power is not supplied even if you make a USB connection using the multi-use terminal USB cable. If you connect the camera and a computer using the multi-use terminal USB cable when the camera is in playback mode, the display on the camera is changed from the playback screen to the USB connection screen. X Memory cards that you can use Memory card Memory Stick PRO Duo A Memory Stick PRO-HG Duo Memory Stick Duo SD memory card B SDHC memory card SDXC memory card For still images a a a a a a For movies a (Mark2 only) a -- a (Class 4 or faster) a (Class 4 or faster) a (Class 4 or faster) In this manual, products in A are collectively referred to as "Memory Stick Duo" media, and products in B are collectively referred to as SD card. X To remove the memory card/battery pack Memory card: Push the memory card in once. Never remove the memory card/battery pack when the access lamp (page 8) is lit. This may cause damage to data in the memory card/internal memory. It may take time for the power to turn on and allow operation. 3 Select the desired area following the instructions on the screen, then press z. [. . . ] Sony cannot compensate for failure to record or loss or damage of recorded content due to a malfunction of the camera or recording media, etc. Clean the camera surface with a soft cloth slightly moistened with water, then wipe the surface with a dry cloth. To prevent damage to the finish or casing: ­ Do not expose the camera to chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent, sunscreen or insecticide. Illustrations used in this manual are of the DSC-WX7 unless noted otherwise. [. . . ]