User manual SONY DSR-1800A

[. . . ] 3-869-572-11(2) Digital Videocassette Recorder Operating Instructions Before operating the unit, please read this manual thoroughly and retain it for future reference. DSR-1800A/1800AP © 2005 Sony Corporation Owner's Record The model and serial numbers are located at the rear. Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Serial No. WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] A PRESET [>>A preset]: For details, see "Setting Points A and B for Repeat Playback" Specify a time code on page 35. value to be used as the setting of point A. B PRESET [>>B preset]: For details, see "Setting Points A and B for Repeat Playback" Specify a time code on page 35. value to be used as the setting of point B. Menu Contents 55 OPERATIONAL FUNCTION [Operational]: Operation settings AUTO EE SELECT [> Auto EE]: CASSETTE OUT [>> Determine whether the unit Cass. out]: Operations enters EE mode or PB mode when the cassette has when audio and video been ejected signals from other equipment F. REW]: Operations When this unit is used as the when in fast forward or recorder for cut editing, it is rewind mode possible to output the input audio and video signals to STOP [>> STOP]: the monitor. This enables Operations when in editing operation to be stop mode carried out using a single monitor. STANDBY OFF [>> STBY OFF]: Operations when in standby off mode LOCAL ENABLE [> Local ENA]: Select which of the tape transport control buttons (EJECT, REW, PLAY, F FWD, STOP, and REC) operate when the REMOTE button is lit. Description of settings *EE [>>> EE]: Output video and audio signals received from other equipment. PB [>>> PB]: Mute video and audio signals. EE [>>> EE]: Output video and audio signals received from other equipment. *PB [>>> PB]: The unit enters playback mode and outputs a playback video signal. EE [>>> EE]: Output video and audio signals received from other equipment. *PB [>>> PB]: The unit enters playback mode and outputs a still picture. EE [>>> EE]: Output video and audio signals received from other equipment. *PB [>>> PB]: The unit enters playback mode and outputs a still picture. ALL DISABLE [>> All DIS]: All of the tape transport control buttons are disabled. *STOP & EJECT [>> STOP & EJ]: Only the STOP and EJECT buttons are enabled. ALL ENABLE [>> All ENA]: All of the tape transport control buttons are enabled, and settings such as preroll time change or time data display selection are effective. *OFF [>> OFF]: Do not prohibit recording on tape. ON [>> ON]: Prohibit recording on tape. (The REC INHIBIT indicator on the front panel lights. ) REC INHIBIT [>REC INH]: Determine whether to prohibit recording on tape. A1 EDIT CH [> A1 Edit CH]: Determine which audio channel *CH-1 [>> CH-1]: Assign to channel 1. the EDIT PRESET command set on an editing control unit CH-2 [>> CH-2]: Assign to channel 2. [. . . ] R-Y signal A chrominance signal determined by subtracting the Y (luminance) signal from the R (red) signal. Reference video signal A video signal consisting of a sync signal or sync and burst signals, used as a reference. Setup (for DSR-1800A) The difference between the reference black level and the blanking level of a composite signal. SMPTE Abbreviation of Society of Motion Picture and Television Engineers, a professional association established in the USA. 98 Glossary S/N Abbreviation of Signal-to-Noise (ratio). [. . . ]