User manual SONY DTC-2000ES

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Each time you press the button, the displayed information changes as follows. You can locate the tracks in a number of ways, but only after you have recorded start IDs on the tape (see pages 15 to 18). To use Direct Access, program numbers must be recorded on the tape (see pages 15 and 18). You can play a specific track or all the tracks on the tape repeatedly. The beginning of the next or succeeding tracks (AMS) The beginning of the current track(AMS) The beginning of preceding tracks (AMS) ± as many times as you want while playing. For example, to locate the second track ahead, press twice. Once while playing as many times as you want while playing. For example, to locate the second track behind, press three times. 1 Enter the program number of the track with the number buttons. Press REPEAT repeatedly while playing a track until "REPEAT" appears in the display. The deck will then play back all tracks until it detects the end of the last track, which may be: -- a blank section of 9 seconds or more -- the end of the tape When the deck detects either of the above, it rewinds the tape to beginning and plays back all tracks again. When recording a digital signal with the INPUT switch at OPTICAL or COAXIAL A start ID and program number are written whenever a new track is detected while recording a digital signal through the COAXIAL IN or OPTICAL IN jack from a digital source such as CD player or another DAT deck. Start IDs and program numbers are not written, however, for tracks that are less than 18 seconds in length. You can write start IDs during playback. If you are recording from the end of the recorded portion, use the number buttons on the remote to specify the program number after the last one recorded. Example: When program number 5 is the last program number recorded on the tape. "ID WRITE" appears in the display for a few seconds and the start ID is written on the tape at the selected position. The next program number When you arrive at the proper position. "REHRSL" appears , "START ID" flashes in the display and Rehearsal repeats a 3-second portion starting from the selected position. Note that the repeated portion will play back 8 times, with the remaining number of times appearing to the right of the "REHRSL". After 8 times, the deck automatically stops. Press 0 or ) to move the beginning of the repeated portion. [. . . ] The deck cannot be operated with the remote (supplied). / A safety mechanism is operating because of condensation. Remove the cassette and leave the deck turned on for about an hour. Then turn the deck off, then on again (see page 18). [. . . ]