User manual SONY DTC-57ES

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] The deck will then play back all tracks until it detects the end of the last track, which may be: -- a blank section of 9 seconds or more -- the end of the tape When the deck detects either of the above, it rewinds the tape to beginning and plays back all tracks again. The deck repeats this cycle up to 5 times, then automatically stops. Repeat Play of all tracks is canceled when you take out the cassette. By specifying the program 1 Enter the program number of number of a track the track with the number buttons. Playing a track repeatedly Press REPEAT repeatedly while playing the track that you want until "REPEAT 1" appears in the display. The deck will then play back the track until its end, which may be: --the next start ID --a blank section of 9 seconds or more --the end of the tape When the deck detects any of the above, it rewinds the tape and starts playing from the start ID of the same track again. The deck repeats this cycle up to 5 times, then automatically stops. To stop playing a track repeatedly If you enter the wrong program number during Direct Access Z If you haven't pressed the ( button, press the CLEAR button on the remote, then enter the correct number. If you have already pressed the ( button, pressing the CLEAR button will not erase the wrong program number. If the deck detects a blank section of 9 seconds or more, or the end of the tape The deck rewinds the tape automatically to its beginning and stops (Auto Rewind). Repeat Play of a single track is canceled when you take out the cassette. Note that the repeated portion will play back 8 times, with the remaining number of times appearing to the right of the "REHRSL". After 8 times, the deck automatically stops. Press REW 0 or FF ) to move the beginning of the repeated portion. Each time you press the REW 0 or FF ) button, the beginning of the repeated portion shifts backwards or forwards in 0. 3-second increments, up to a maximum extent of about 2 seconds (4 seconds in long-play mode) in either direction. During playback, press START ID REHEARSAL when the existing start ID you want to reposition is displayed. You can move the start ID to a maximum extent of about 2 seconds (4 seconds in long-play mode) in either direction from its original position. 3 sec Start IDs written within 10 seconds from the end of the tape may be difficult or impossible to move. The time in the display shows the shift in position from the time the START ID REHEARSAL button was pressed. After pressing FF ) twice After pressing REW 0 twice You can erase any start ID. "ID WRITE" appears in the display for a few seconds and the start ID is written on the tape at the selected position. [. . . ] "CAUTION" appears and the deck cannot be operated. / A safety mechanism is operating because of condensation. Remove the cassette and leave the deck turned on for about an hour. Then turn the deck off, then on again (see page 17). [. . . ]