User manual SONY DVP-LS755P

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. The mains lead must only be changed at a qualified service shop. Check that the unit's operating voltage is identical with your local power supply. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. [. . . ] Each channel is output from a separate speaker. Rear (Monaural): This signal can be either the Dolby Surround Sound processed signals or the Dolby Digital sound's monaural rear audio signals. See the explanations given for each item in the following section. If "DTS" in "AUDIO SETUP" is set to "OFF, " the DTS track selection option will not appear on the screen even if the disc contains DTS tracks (page 71). MPEG audio signals with more than two channels will appear as shown above (3/2. 1, 2/1), but only the Front (L) and Front (R) signals will be output from your two front speakers. TVS DYNAMIC Creates one set of virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers (shown below). This mode is effective when the distance between the front L and R speakers is short, such as with built-in speakers on a stereo TV. TVS WIDE Creates five sets of virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers (shown below). This mode is effective when the distance between the front L and R speakers is short, such as with built-in speakers on a stereo TV. When the playing signal does not contain a signal for the rear speakers, the surround effects will be difficult to hear. When you select one of the TVS modes, turn off the surround setting of the connected TV or amplifier (receiver). Make sure that your listening position is between and at an equal distance from your speakers, and that the speakers are located in similar surroundings. TVS NIGHT Large sounds, such as explosions, are suppressed, but quieter sounds are unaffected. This feature is useful when you want to hear the dialog and enjoy the surround sound effects of "TVS WIDE" at low volume. TVS STANDARD Creates three sets of virtual rear speakers from the sound of the front speakers (L, R) without using actual rear speakers (shown below). Use this setting when you want to use TVS with 2 separate speakers. If subtitles are recorded on the discs, you can change the subtitles or turn them on and off whenever you want while playing a DVD. Depending on the DVD VIDEO, you may not be able to change the angles even if multi-angles are recorded on the DVD VIDEO. Depending on the DVD VIDEO, the choice of language varies. When 4 digits are displayed, they indicate a language code. To turn off the subtitles Depending on the DVD VIDEO, you may not be able to change the subtitles even if multilingual subtitles are recorded on it. [. . . ] the data capacity of a single-layer and singlesided DVD is 4. 7 GB (Giga Byte), which is 7 times that of a CD. The picture data is compressed to about 1/40 (average) of its original size. The DVD also uses a variable rate coding technology that changes the data to be allocated according to the status of the picture. [. . . ]